Bowers and Wilkins T7 Battery Replacement

Introduzione

Use this guide to learn how to replace your battery for the Bowers and Wilkins T7 Bluetooth Speaker.

As with all electronic devices, make sure your device is powered off before you begin.
Gently lift up the access panel; it should easily "pop" open.

Be gentle, the rubber seal is fragile and easy to tear, resulting in cosmetic damage to your device.
Using the ifixit Opening Tool, carefully pry off the rubber seal around the sides.
The seal is held by adhesive, if this is proving difficult you can use a heat gun to help the process.

The cover is the most difficult part to remove. As you work, pry continuously, moving the tool around the device, working it a little further as you go.
Using the ifixit Opening Tool, pry open at the seam found under the rubber seal.
As the cover starts to come off, you can lift up using your hand.

Attrezzo utilizzato in questo passaggio:

Tweezers

$4.99

Acquista

Gently squeeze the internal locking mechanism inside the red and white terminals with either your fingers or a pair of precision tweezers.
While squeezing the internal locking mechanism, pull back the terminal.
Repeat this process for the second speaker.

Using a cutting tool such as a Jimmy steel blade or wire cutter, cut the cable tie surrounding the battery.
Be careful not to damage the battery while cutting the cable tie surrounding the battery.