Apalus Digital Hair Straightening Brush Heating Element Replacement

Introduzione

Use this guide if you need to replace the heating element of your Apalus Digital Hair Straightening Brush. If your brush is not heating up, this guide will walk you through how to take apart the brush in order to replace the heating element. Soldering is involved, so if you don't know how to solder take a look at this Come saldare e dissaldare componenti elettrici guide.

Cosa ti serve

Passo 1 Heating Element

Apalus Digital Hair Straightening Brush Heating Element Replacement, Heating Element: passo 1, immagine 1 di 1

Remove the seven 5mm Phillips #1 screws on the comb-side of the brush.

Traduci

Passo 2

Turn comb over so the bristles are facing down.
Remove backside of the comb and place aside.

Traduci

Passo 3

Unplug the power cord from the connector inside of the brush.

Traduci

Passo 4

Remove the circuit board and heating element from the handle.
This will provide easy access to the necessary components.

Traduci

Passo 5

Remove the four 6mm Phillips #2 screws holding the heat shield onto the back side of the bristles.

Traduci

Passo 6

There are 4 solder points of the heating element located on the LCD side of the circuit board.
Desolder these four connections using a soldering iron.
Note which wires go to each of the connection points.
Soldering Technique Guide