Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the seven 5mm Phillips #1 screws on the comb-side of the brush.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Now that the screws are taken out, remove the backside of the comb.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unplug the power cord from the insert inside of the brush.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the circuit board and heating element from the handle.
-
This will make it easier to work on for later steps.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the three buttons on the bottom side of the circuit board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Each button is soldered in four places on the circuit board. Using the soldering tool, melt each of these four points and remove the dysfunctional buttons.
-
You may have to bend the dark red capacitor out of the way to reach the soldering points.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Now that the dysfunctional buttons are removed, use a soldering tool and solder to install the new buttons on the circuit board.
-
Solder at the same four points as when previously melting these points to remove the buttons.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.