Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place the plastic opening tool in the space between the rubber and the plastic case of the device.
-
Apply pressure by pushing upward on the case.
-
Separate the bottom square rubber piece from the case using the plastic opening tool until all clips are detached.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the ten J#00 Phillips screws and remove them.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place your finger on the short edge of the motherboard and lift it to separate it from the plastic case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
With the mother board back facing you locate the power cord port found on the far left end.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the four soldering joints for the power cord port found on the top side of the mother board.
-
Desolder the joints of the power cord port to release it from the motherboard.
-
Place the new power cord port into its original location and solder its joints.
-
Use the iFixit soldering and desoldering guide.
-
Annulla: non ho completato questa guida.
Altre 5 persone hanno completato questa guida.
2 Commenti
Aonde compro essa fonte ? wagnerj957@gmail.com
Ola moro no Brasil minha fonte queimou aonde compro outra?