Introduzione

A guide on how to replace the touchscreen on a Acer Aspire V5-571P-6815 laptop.

  1. Turn off the computer and unplug all power.
    • Turn off the computer and unplug all power.

  2. Slide the locking latch to the right and hold while pulling the battery out with your other hand. Slide the locking latch to the right and hold while pulling the battery out with your other hand.
    • Slide the locking latch to the right and hold while pulling the battery out with your other hand.

  3. Insert a plastic opening tool between the screen and lid. Work the plastic opening tool around the perimeter while prying upwards until the screen separates from the lid.
    • Insert a plastic opening tool between the screen and lid.

    • Work the plastic opening tool around the perimeter while prying upwards until the screen separates from the lid.

  4. Lay the screen flat down on the keyboard.
    • Lay the screen flat down on the keyboard.

  5. Spedizione gratuita per tutti gli ordini superiori a 100 US$ o contenenti un Kit Attrezzi Pro Tech!

    Sfoglia il Nostro Negozio
  6. Remove the camera using a pair of blunt nose tweezers. Peel up the adhesive tape keeping the camera's cable tied down.
    • Remove the camera using a pair of blunt nose tweezers.

    • Peel up the adhesive tape keeping the camera's cable tied down.

  7. Remove the microphone from the motherboard with a pair of blunt nose tweezers. Slide out the adhesive tape securing the microphone cable.
    • Remove the microphone from the motherboard with a pair of blunt nose tweezers.

    • Slide out the adhesive tape securing the microphone cable.

  8. Lift up the ribbon cable contained by the adhesive strip with blunt nose tweezers. This will allow you to access the two black digitizer ribbons. Use a spudger to flip up the retaining flap on the digitizer ribbon cable ZIF socket.
    • Lift up the ribbon cable contained by the adhesive strip with blunt nose tweezers.

    • This will allow you to access the two black digitizer ribbons.

    • Use a spudger to flip up the retaining flap on the digitizer ribbon cable ZIF socket.

    • Pull the ribbon cables out of their sockets.

  9. Remove the board form the laptop. Remove the board form the laptop.
    • Remove the board form the laptop.

  10. Use the blunt nose tweezers to peel up the adhesive on the display cable. Pull on the adhesive tape to disconnect the display from the motherboard.
    • Use the blunt nose tweezers to peel up the adhesive on the display cable.

    • Pull on the adhesive tape to disconnect the display from the motherboard.

  11. Lift the whole strip connected to the circuit board and  LCD connector. Place the strip to the side where it is not in contact with the screen. Remove the whole screen from the device.
    • Lift the whole strip connected to the circuit board and LCD connector. Place the strip to the side where it is not in contact with the screen.

    • Remove the whole screen from the device.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Brianna Sinder

Membro da: 12/04/2018

353 Reputazione

2 Guide realizzate

Team

UW Tacoma, Team S1-G4, Liner Spring 2018 Membro di UW Tacoma, Team S1-G4, Liner Spring 2018

UWT-LINER-S18S1G4

5 Membri

4 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 65

Tutti i Tempi: 474