Aggiusta la tua roba Comunità Store

ATT CL2940 Speakerphone Replacement

Scritto Da: Charles Messmore (e 7 altri collaboratori)
  • Commenti: 1
  • Preferiti: 1
  • Completamenti: 1

Difficoltà

Moderato

Passi

6

Tempo Necessario

30 - 40 minuti

Sezioni

2

Contrassegni

1

Better Introduction

Introduzione Migliore

Migliora questa guida completando o revisionando la sua introduzione.

Introduzione

A speakerphone is used to talk hands-free on the phone. This guide will educate you on how to replace one if it is part of your ATT CL2940.

You will need to solder to complete this guide. If you are not familiar, check out this article for an introduction.

  1. Remove five 9.5 mm Phillips #1 screws from the back panel of the phone. Remove five 9.5 mm Phillips #1 screws from the back panel of the phone. Remove five 9.5 mm Phillips #1 screws from the back panel of the phone.

    • Remove five 9.5 mm Phillips #1 screws from the back panel of the phone.

    Traduci

  2. Slide the metal spudger into the crack and continue around to the front panel of the phone. Be careful not to break the clips that hold the back panel to the front panel. Be careful not to break the clips that hold the back panel to the front panel.

    • Slide the metal spudger into the crack and continue around to the front panel of the phone.

    • Be careful not to break the clips that hold the back panel to the front panel.

    Traduci

  4. When setting the back panel down, be careful to not rip any of the wires off of the internal components.

    • When setting the back panel down, be careful to not rip any of the wires off of the internal components.

    Traduci

  5. Remove the front panel of the device as shown. Remove the front panel of the device as shown.

    • Remove the front panel of the device as shown.

    Traduci

  6. Desolder the speakerphone with a soldering iron. If you are unfamiliar with solder, check out the article on soldering and be very careful. The iron is hot! If you are unfamiliar with solder, check out the article on soldering and be very careful. The iron is hot!

    • Desolder the speakerphone with a soldering iron.

    • If you are unfamiliar with solder, check out the article on soldering and be very careful. The iron is hot!

    Traduci

  7. Use the soldering iron to reconnect the wires to the new speaker. Place the new speaker back in place.

    • Use the soldering iron to reconnect the wires to the new speaker.

    • Place the new speaker back in place.

    • Make sure that all of the components are back in place.

    Traduci
Linea Traguardo

Un'altra persona ha completato questa guida.

Autore

con 7 altri collaboratori

Charles Messmore

Membro da: 15/02/2016

541 Reputazione

5 Guide realizzate

Distintivi: 12

+9 altri distintivi

Team

IUPUI, Team 1-1, Harley Spring 2016 Membro di IUPUI, Team 1-1, Harley Spring 2016

IUPUI-HARLEY-S16S1G1

4 Membri

13 Guide realizzate

Un commento

Why do all these repairs require NO PARTS to replace defective parts?

And, of course< there is no links to a place to purchase the needed parts...

rpoland - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 476