Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Fold up your center console and take a seat with a good view of your stereo.
-
Locate the screw in the bottom right hand side of the console, just above the coat hanger hook.
-
Remove the 12mm long #2 Phillips screw with a #2 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lower the cup holder and trash receptacle to allow better access to the bottom lip of the console trim.
-
Grasp the bottom right hand corner of the console trim and slowly pull toward you. Gradually increase your force until the you feel the right side clips pop off.
-
Repeat again on the bottom left side of the clips to fully remove the anchoring clips.
-
Once the clips are popped out, slowly lower the face plate and lay it down, supported by the wires coming out the back side.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate and remove the four anchoring 12mm long #2 Phillips screws for the head unit using the #2 screwdriver.
-
It is now safe to pull out the head unit. Support it in one hand to reduce tension in the cables.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Support the unit in one hand to remove tension from the wiring harness.
-
Pinch the multi-wire connector and pull away from the unit to disconnect.
-
Remove the 4 RCA cords by simply pulling them out of each jack.
-
Annulla: non ho completato questa guida.
Altre 9 persone hanno completato questa guida.
7 Commenti
This should be listed for Ram 1500 2002-2005 years. The 2500/3500 kept this dash longer, until 2006.
It looks exactly like my 2002 Dodge Ram 1500 SLT Quad Cab 4.7 Liter V8.
I have a radio that turns on, has power because the blue light turns on, but nothing comes on the screen, there is no sound and nothing will play. Any ideas?