Wiki con Collaborazione Studenti
Un fantastico team di studenti del nostro programma educativo ha realizzato questo wiki.
Device Will Not Charge
The Deebot D35 will not show any signs of charging or powering on.
Device Power is OFF
If the device does not show signs of power, check the bottom of the Deebot. Locate the power switch and set to the the ON position. If the power switch is already in the ON position change the switch to the OFF position and manually dock it to the charging station. After three hours attempt to turn on again.
Discharged Battery
The battery is completely discharged. Reactivate the battery. Place Deebot on the charging dock by hand, remove after charging for 3 minutes, repeat 3 times, then charge normally.
No Connection With the Charging Dock
Deebot has not made a connection with the charging dock. Be sure that Deebot has made a connection with the charging dock pins. Move the robot manually to make the connection if necessary.
Battery Will Not Hold a Charge
The battery is maintaining a full charge for as long as specified:
Battery Has Been Idle
Battery has not been used in a long time and lost some of it’s capability to hold power. Place the robot on charging dock by hand, remove after charging for 3 minutes; repeat 3 times. Charge normally for 3-5 hours. If device still does not charge the battery may need to be replaced.
Battery Needs to be Replaced
The battery is faulty and is unable to hold charge or be charged. Push tabs on both sides of the battery pack to remove. Insert new battery pack and press until it's fully locked into place.
The guide to removing the battery can be found here: Deebot D35 Battery Replacement Guide
Device is Obstructed and Has Stopped Working
The device is tangled with something on the floor. For example, electrical cords, drooping curtains, area rug fringe, etc.
Obstruction and Entanglement
The Deebot D35 has encountered an obstacle and stopped the device from functioning correctly. Turn the device off. Gently lift the Deebot D35 and remove any obstacles such as power cords, area rugs or curtains in the path of the device to correctly function. If the device still has issues, remove dust bin and filter and remove debris.
One can also clean out the Deebot's vacuum motor.
The guide to removing the vacuum motor can be found here: Deebot D35 Vacuum Motor Replacement Guide
Charging Station Re-Docks Before Cleaning is Finished
If the battery is low, then the Deebot will automatically switch to Return to Charger Mode, and will return to the charging dock to recharge which is normal and no solution is required.
Floor Surface and Room Complexity
The amount of time it takes the Deebot to clean depends on what surface it is working on and/or how complex the room is. If the room is too complex, it may return to the charging station to recharge before completing the cleaning.
Automatic Scheduled Time Issues
The device is having trouble completing its automatically scheduled task on time or completely.
The Scheduling Function is Cancelled
Reset Deebot by pressing and holding the start/pause button for 3 seconds. Set the current time. Once the scheduling has set successfully, the device will beep 3 times and indicator light will turn blow. If the scheduling is cancelled, the device will beep 3 times and the indicator light will turn green.
If necessary, one can remove and replace the Deebot's motherboard.
The guide to removing the motherboard can be found here: Deebot D35 Motherboard Replacement Guide
The Device Power is OFF
Make sure that the device’s bottom power switch is turned on. If the device still does not function replace the device manually on the charging station.
The Device Battery is Low
Keep the device powered on and connected to the charging dock (this will make sure it will have a full battery to work for the next usage).
The Device Suction Blocked/Tangled
Turn the device power off. Clean the dust bin. Clean the Universal Wheel by removing any obstructions/hair tangled around the area. Use a dry cloth to wipe down the Anti-Drop sensors located in the front of the backside of the device. Use a dry cloth to wipe down the charging contacts both on the device and charging dock pins. They are located on the top left and right of the device in between the Universal wheel and and the side brushes. Be sure to wipe the sensor on the charging dock pin as well.
One can also clean out the Deebot's vacuum motor.
The guide to removing the vacuum motor can be found here: Deebot D35 Vacuum Motor Replacement Guide
Device Has Lost Suction
The device in not intaking at its full capacity.
Clogged Dustbin and/or Air Filter
Turn the device power off. Clean the suction intake and brushes gently with a dry paper towel. Gently open the top of the device and remove the dustbin. Empty the dustbin of all debris. Gently remove the attached air filter. Take the air filter and gently pat it removing dust and build up. Set the air filter aside and take the dustbin and wipe it down with a moist towel. Let the dustbin dry completely. Replace the filter in the dustbin and then slide the dustbin back into the devices housing.
One can also clean out the Deebot's vacuum motor as well as its side brushes.
The guide to removing the vacuum motor can be found here: Deebot D35 Vacuum Motor Replacement Guide
The guide to removing the side brushes can be found here: Deebot D35 Side Brushes Replacement Guide
Team
USF Tampa, Team 12-2, Eyestone Spring 2017 Membro di USF Tampa, Team 12-2, Eyestone Spring 2017
USFT-EYESTONE-S17S12G2
4 Membri
4 Guide realizzate
43 Commenti
Where do i buy a new battery?
Kay Pott - Replica
I have a n79 that just goes in circles and stops. Its charged. The only thing i can think of is that we just moved and have no internet/wifi service.
h2opdler - Replica
Mine has been doing the same thing.
jesstrav1 -
maybe a front bumper issue, older models buttons can jam on the case inside, newer models lose tension in the spring that returns the button.
Alex Korbey -
maybe a front bumper issue, older models buttons can jam on the case inside, newer models lose tension in the spring that returns the button.
Alex Korbey -
I have the slim 2 . After using it (still runs for over an hour. )I charge it. When it's done charging it discharges itself on base. And I have to charge it all over again to use it. :((
Nelly Ivos - Replica
The robot will “turn blow”? Nice.
Adam Plocher - Replica
Help…the deebot runs for about 15 or 20 seconds then stops and starts beeping. Replaced battery and fully charged, replaced all brushes. Does run like its battery isnt charging, just stops. Depend on it. What is wrong????
L as urel Graves - Replica
I have the same problem. Have you figured it out?
Sween -
Me too, just starts beeping, every time I put in on charging dock, does it need a new battery and where can I but a Deebot SC1800 mAh 12v battery?
johnbreheny-June 9th 2019
brehondownunder -
Ok for anyone who has similar problem. . Ecovacs said its the brush motor. Sonce they dont have a repair facility if its out if warranty theres no solution but buy a new one. I did that . Now every time i empty the dustbin i conscientiously check to mske sure nothings wound around brush. Also best to run it when you are around and listen for it to get hung up in cords or throw rugs.
L as urel Graves -
I Have the same issue wish I could help you I'm leaning towards badd battery but Hey to buy one and have it not work
Lonnie Bailey -
Same thing has happened to mine. I have not replaced the battery yet-just for this at Christmas so it’s only been in use for 4 months. How long should the battery last?
h.collins - Replica
Mine too - I use it daily for nearly a year and it’s cleaned and charged. Sending is back.
janicebailey2004 - Replica
Please help
the deebot give no sign of power, when placed on the charging dock battery flashes red / green. I let the deebot in this situation over night but still no power and not working
hijustmen - Replica
My deebot 600 not working even I replace the new battery. They will turn off when I remove it from charging dock.
maxpeter85 - Replica
Ecovacs DN622-11 is totally dead an will not charge with power switch on or off. No lights, no nothing. Only had it for 2 months warranty just expired, of course! Checked continuity of power switch and it is good. I could not find any fuses on the main board or elsewhere.
Edwin Jackson - Replica
The forward button on the control is not working. How do I fix it please?
ecovacs remote model RC1633
Claud - Replica
My deebotn79w starts automatically at midnight. I have deleted the auto start but three nights in a row I have gotten up in the wee hours to turn it off. I have also done a reset on the unit itself by pressing the auto button until it beeps three times.
Sandy B Brock - Replica
My ECOVAc stops and stays in the Same spot can’t move until you touch him then he continues this happens once or twice every cleaning
Nick - Replica
My deebot has decided to make up it's on schedule at midnight. We have it scheduled for the afternoon and all of the sudden it decided to go in the middle of the night. How do I fox this?
rlmalan - Replica
When my Deebot goes on the charger the right brush keeps turning and will not stop unless I turn the switch off. Naturally, it will not charge with the switch off.
tallyho8 - Replica
My deebot is model DC3G. When I start it it sounds and works fine. About 10 seconds into the cleaning the blower or suction stops and the brushes stop but the vacuum keeps going; not cleaning or picking up anything. I'm not entirely sure how to fix this. I have cleaned brushes, unplugged the battery and plugged it back together, cleaned the sensors. What else can I do so I can get this back to working condition? Havent had it for more than 6 months and use it daily, until recently anyways. Please help!
meghanann3689 - Replica
I have a D35 that I haven’t been used in some time, have lost the manual for it and when I plug it in an place the cleaner on the charger it lights up with all the lights and beeps 4 beeps. What is wrong?
Jimmie guyton - Replica
When I had a charge with a customer rep, they told me 4beeps with steady red light means main brush needs some cleaning. Remove the main brush and let it run and see if its still happens to identify the prob.
Sirisha Srinivasan -
How do I stop Deebot from coming on automatically
Gail Dime - Replica
I am hoping someone might be able to help. Recently my Ecovac moves away from the dock and the status changes to cleaning but then after not even 1 second the status updates back to charging and it goes back to the dock. The battery is charged and full and has been doing this for about a week now. It does the same thing if I tell it to clean in the app, hit the auto button on the vac or the schedule time cleaning.
Alicia Keddie - Replica
Mine is doing the same thing. Did you find a fix?
Josh Kelshaw -
I have a DN622 and it isn't holding the charge. When I charge it on dock or directly with adapter, the blue light keeps flashing for about 5mins and the light goes off and goes blank.. I replaced it with new battery and all new brushes assuming this was its prob but nothing worked. Please help
Sirisha Srinivasan - Replica
I have problem (LDS malfunction) and I don’t now how fix it
Kawthar E - Replica
5 beep anit-drop sensor error. Sensors clean but still not working? Any suggestions
Zobak The Son - Replica
My DEEBOT seems to NOT be able to go up the ramp of the dock... it has NO power yet the battery is fully charged. Would this be a battery replacement fix??
jonatan Odicio - Replica
It drove me nuts as was working perfectly. Then I decided to pop a flattened cardboard box underneath the back rim created a very slight slope and up she went.
Gay Macdonald -
When unit is fully charged it will start beeping and doesn’t stop. How do I fix?
janalynmoore3 - Replica
My Deebot has two missing holders for the brush attachments. Can I replace them?
Christi Drake - Replica
I keep getting a message "Please install dust bin" and it's installed. Found tiny magnet in dust bin. Help! Where does the magnet go?
Robin - Replica
I have changed the battery and charging dock, my Deebot still won’t charge the blue light come on make a beep noise and switches off, could someone please advise what else could be wrong?
Corey Bray - Replica
We have installed a new battery but its stopping frequently and im needing to switch the machine on and off to restart, but still not going full time
vickicroydon - Replica
Mines is only going backwards
Satvik - Replica
The starting point must be on a hard floor, not carpet.
Brian Poulsen -
keeps repeating i am suspended and will not reset. i have fully charged, completely powered off and reset
becky - Replica
I have a debot T9+ , had issues with charging and power. Replaced the battery with a new one and still cannot get a charge keeps saying low battery powering off . Have tried the above 2 methods to get some charge into the machine with no luck .. it has definitely docked correctly and made contact with the connections any advice on other things to try ?
Daniel - Replica
Cannot get into the app to reset the time. Rob is cleaning at 9 pm. Need to change to a.m.
Sylvia Smith - Replica