Rispondi a: NO WIFI greyed out.I know this post is old, but maybe this information may help someone else out, I have repaired a lot of iPods and have run across this issue several times. One example I have in mind is an iPod 2gen that had gotten wet (the moisture indicator was bright red). I was able to bring most of it back from the dead, but was unable to get wifi to work...the wifi selector was grayed out under the settings. I took it back apart to look at it again. The wifi assemble is at the top right corner of the device, right behind the black shield that is visible on the backside of the outer stainless shell. If you remove the three screws that holds the entire top pcb assembly in place, and gently lift the ribbon wire that connects the top and bottom half, on the backside of the top PCB assemble, you will see a small rectangle metal cover. This covers the broadcom chipset for the wireless. In this particular iPod, I noticed some scorching on this cover. I gently pried the cover up from one of the lengthwise sides. Be careful, thi...
Rispondi a: Digitizer not snapping into place/button not seatedI would also make sure that the battery, mainboard and stainless cover are seated properly. Also, make sure that the screws are screwed all the way in. And of course, follow Oldturkey03's suggestion and make sure that you installed the correct part. Good luck!
Rispondi a: Device won't power on, not recognized via USB either...I had this issue with a neighbor's ipod touch 2g 8 gb. It turned out the two of the pins were broke/bent. However, the power button functioned properly. Maybe worth checking out. I had to use a penlight to see the bent pens. Specifically, here is what happened to this ipod. Since one of the pins was broken (I think it was Pin 23) it would not power and the battery had long since ran out. In all appearances, the Ipod appeared to be bricked. But only the ability to charge the ipod was defective. The good news is that I was able to re-soilder a replacement doc connector on for only around two bucks. But I got to warn everyone, those pins are really tiny. Hope this may help you or someone else out