I have an iPad 2 3G, I fixed the broken digitizer after using the iPad as it was for around a month.... I also ripped the...

I attempted repairing my housing, and it's not bad I would say, I used a mini chisel with pointed ends, after taking the skinny plastic frame off... Now it's not skewed, and have fitted it back in and taped it up from the outside to see if it's a perfect fitt.. Well it will never be perfect, but as long as its out of the way of the digitser glass...

I have an iPad 2 3G, I fixed the broken digitizer after using the iPad as it was for around a month.... I also ripped the antenna from it's 3 screws securing it to the metal back housing, the wifi worked for a bit, Bluetooth also sometimes worked. Having seen the price of the antenna and the realizing the hardest part I had already done, I ordered the the antenna fitted it in, and no wifi... No bluetooth.... WHEN I stand next to my router, I suddenly get a bar of wifi signal, but still no Bluetooth... Really gutted, I want to seal this iPad back up, but It's really doing my nutt in... I refuse to give up.... I checked the continuity on the mini coaxial cable that connects to the logic board and it's shorting.... On the old antenna and the new one I bought, I was wanting to share results, can anyone do the same with an antenna they have spare or in fron of them... I know it's really small cable and it has 2 cores so are very easy to damage..l BUT I need to know, if anyone's reading? Is there continuity at...

The iPad does not like you turning it on or off, whilst disconnecting any of it's cables.... TRY NOT TO TURN IT ON OR OFF WHILST DOING THIS REPAIR... If this does happen to you, as it happened to me, all you need to do is press the power button with the home button for 7 or so seconds for it to hard reset. (which may be a bit tricky if you have the digitizer off with a hanging home button, but you will figure how to do it after a few tries... Also if there is no pic but is sound then you need to disconnect and connect the LCD and or digitizer connectors in properly pushed all the way in, along with the control board to logic board cable tab in a closed position or it won't function, even if it's connected in....