Strumenti necessari in questo Smontaggio

Introduzione

This is a basic teardown of the venerable TI-82 calculator.

Questo smontaggio non è una guida di riparazione. Per riparare il tuo Texas Instruments TI-82, usa il nostro manuale di assistenza.

The calculator comes with a matching protective shield which slides down over the front; when the calculator is in use, you can slide it over the back.  This is a nice touch, as it makes the cover much more difficult to lose.
  • The calculator comes with a matching protective shield which slides down over the front; when the calculator is in use, you can slide it over the back. This is a nice touch, as it makes the cover much more difficult to lose.

Aggiungi Commento

Flip the device over to access the battery cover. Using a spudger, pry the release tab down and then pull the battery door up and off the calculator. Remove:
  • Flip the device over to access the battery cover.

  • Using a spudger, pry the release tab down and then pull the battery door up and off the calculator.

  • Remove:

    • 2 7.2mm Phillips #0 screws

    • 1 15.3mm Phillips #0 screw, and a battery retaining clip.

  • The CR1616 coin cell battery preserves settings and programs in memory while the main batteries are being changed.

Aggiungi Commento

Kit RAM Mac
Accelera il Mac. Porta la memoria al massimo.
Kit RAM Mac
Metti più memoria nel tuo Mac.
Insert a spudger into the seam between the two halves of the case, and pry it apart.
  • Insert a spudger into the seam between the two halves of the case, and pry it apart.

  • Watch out for corrosion in older calculators around the battery terminals -- this is why you should never leave batteries in electronics for extended periods of time.

Aggiungi Commento

Opening the two halves of the calculator reveals a foil shield over the rest of the electronics.
  • Opening the two halves of the calculator reveals a foil shield over the rest of the electronics.

  • Remove four Phillips screws to access the electronics underneath, then pull the shield away.

Aggiungi Commento

... And, here's the guts of the thing.
  • ... And, here's the guts of the thing.

    • SRM20255LLM10 / F4ZM1938 (32Kbyte SRAM)

    • LH531GP4 (Mask ROM)

    • T 84C00AM-8 (Z80 CPU)

    • Toshiba / TC14L010AF / 1273 9506EAI (ASIC)

Aggiungi Commento

Remove the remaining Phillips screws. The screen and main board will lift out, leaving the membrane keypad in the front case.
  • Remove the remaining Phillips screws.

  • The screen and main board will lift out, leaving the membrane keypad in the front case.

Aggiungi Commento

bushing

Membro da: 23/04/2010

9.029 Reputazione

17 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 9

Ultimi 30 Giorni: 76

Tutti i Tempi: 14,644