Strumenti necessari in questo Smontaggio

Introduzione

What you will need:

T6 Screwdriver

Your favorite spudger ( I chose the iSesamo)

This phone is easy and almost impossible to brake. So put any fear you have away and lets crack it open.

Questo smontaggio non è una guida di riparazione. Per riparare il tuo Nokia Asha 200, usa il nostro manuale di assistenza.

Take the back cover off and remove the battery. (Not shown)
  • Take the back cover off and remove the battery. (Not shown)

  • Remove the two screws located with red circles

Aggiungi Commento

Insert spudger between the front/back case and lever untill you hear a click. Slowly work your way around until the bottom end is separated. Then with the bottom end facing your body, try to pull the back case towards yourself. Make sure not to loose Sim2 and Micro SD covers as they easily fall out. Also when re-assembling make sure they are pulled out otherwise you will have trouble putting things back together
  • Insert spudger between the front/back case and lever untill you hear a click.

  • Slowly work your way around until the bottom end is separated. Then with the bottom end facing your body, try to pull the back case towards yourself.

  • Make sure not to loose Sim2 and Micro SD covers as they easily fall out. Also when re-assembling make sure they are pulled out otherwise you will have trouble putting things back together

Aggiungi Commento

Remove the 4 screws marked with red circles There are two clips now holding the circuit board in place. Maneuver the circuit board over one and then pull towards the released clip to release the opposite one. There are two clips now holding the circuit board in place. Maneuver the circuit board over one and then pull towards the released clip to release the opposite one.
  • Remove the 4 screws marked with red circles

  • There are two clips now holding the circuit board in place. Maneuver the circuit board over one and then pull towards the released clip to release the opposite one.

Aggiungi Commento

The lcd screen is held in by a steel bracket. This bracket is held in place by the clips marked with red squares. The easit way to release it is by levering the one on the right (as pictured) and the bracket should come off. When re-assembling make sure the studs marked with blue circles line up properly.
  • The lcd screen is held in by a steel bracket. This bracket is held in place by the clips marked with red squares. The easit way to release it is by levering the one on the right (as pictured) and the bracket should come off.

  • When re-assembling make sure the studs marked with blue circles line up properly.

  • Using a spudger disconnect the LCD cable.

Aggiungi Commento

Congratulations you have successfully dis-assembled the phone. I hope you had as much fun tearing it apart as I did helping you along the way.
  • Congratulations you have successfully dis-assembled the phone. I hope you had as much fun tearing it apart as I did helping you along the way.

Aggiungi Commento

Joel

Membro da: 24/10/2012

207 Reputazione

1 Guida realizzata

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 5

Ultimi 30 Giorni: 28

Tutti i Tempi: 4,402