Xbox 360 Xenon Accessories
Grab a tool kit for your Xbox 360 Xenon model and fix a broken console!
iFixit has you covered with parts, tools, and free repair guides. Repair with confidence! All of our replacement parts are tested to rigorous standards and backed by our industry-leading warranty.
Parti che funzionano con Xbox 360 Xenon:
Xbox 360 Lower Case
Replace the plastic outer casing covering the lower half of the Xbox 360.
Xbox 360 X Clamps
Replace the two X clamps for securing the CPU and GPU heat sinks.
Xbox 360 Bottom Vent
This gray plastic perforated vent covers the bottom face of the Xbox 360.
Xbox 360 Chassis
Replace the stamped steel chassis that provides structural support inside the Xbox 360.
Xbox 360 Eject Button
Replace the plastic eject button.
Xbox 360 RF Module
This small circuit board houses the electronic power button and LED status lights.
Xbox 360 Dual Fans (Early Model)
Replace the dual cooling fans with power cable and four-pin connector for the early model (Xenon) Xbox 360.
Xbox 360 Motherboard Screw Set
This set of screws secures the motherboard to the chassis.
Xbox 360 Faceplate
Replace the plastic face plate including the USB & memory card doors.
Xbox 360 Upper Case Screw Set
This set of screws secures the upper case to the chassis.
The Xbox 360 Xenon was the first revision of the Xbox 360. Unfortunately, the Red Ring of Death has been a very common problem with this revision of the 360. This revision also lacked the HDMI port found on later Xbox 360 models.