Strumenti necessari in questo Smontaggio

Introduzione

This is a basic teardown of the venerable TI-82 calculator.

Questo smontaggio non è una guida di riparazione. Per riparare il tuo Texas Instruments TI-82, usa il nostro manuale di assistenza.

  1. The calculator comes with a matching protective shield which slides down over the front; when the calculator is in use, you can slide it over the back.  This is a nice touch, as it makes the cover much more difficult to lose.
    • The calculator comes with a matching protective shield which slides down over the front; when the calculator is in use, you can slide it over the back. This is a nice touch, as it makes the cover much more difficult to lose.

    Aggiungi Commento

  2. Flip the device over to access the battery cover.
    • Flip the device over to access the battery cover.

    • Using a spudger, pry the release tab down and then pull the battery door up and off the calculator.

    • Remove:

      • 2 7.2mm Phillips #0 screws

      • 1 15.3mm Phillips #0 screw, and a battery retaining clip.

    • The CR1616 coin cell battery preserves settings and programs in memory while the main batteries are being changed.

    Aggiungi Commento

  3. Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    • Insert a spudger into the seam between the two halves of the case, and pry it apart.

    • Watch out for corrosion in older calculators around the battery terminals -- this is why you should never leave batteries in electronics for extended periods of time.

    Aggiungi Commento

    • Opening the two halves of the calculator reveals a foil shield over the rest of the electronics.

    • Remove four Phillips screws to access the electronics underneath, then pull the shield away.

    Aggiungi Commento

    • ... And, here's the guts of the thing.

      • SRM20255LLM10 / F4ZM1938 (32Kbyte SRAM)

      • LH531GP4 (Mask ROM)

      • T 84C00AM-8 (Z80 CPU)

      • Toshiba / TC14L010AF / 1273 9506EAI (ASIC)

    Aggiungi Commento

    • Remove the remaining Phillips screws.

    • The screen and main board will lift out, leaving the membrane keypad in the front case.

    Aggiungi Commento

bushing

Membro da: 23/04/2010

9.244 Reputazione

13 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 28

Ultimi 30 Giorni: 92

Tutti i Tempi: 15,241