Salta al contenuto principale

Cosa ti serve

Questo smontaggio non è una guida di riparazione. Per riparare il tuo Suzuki FA50 Moped, usa il nostro manuale di assistenza.

  1. Suzuki FA50 Moped Throttle Cable Teardown, Suzuki FA50 Moped Throttle Cable Teardown: passo 1, immagine 1 di 1
    • Here is the assembled throttle cable. It seems to be assembled correctly, but certainly does not function properly.

  2. Suzuki FA50 Moped Throttle Cable Teardown: passo 2, immagine 1 di 2 Suzuki FA50 Moped Throttle Cable Teardown: passo 2, immagine 2 di 2
    • The throttle parts.

    • The only logical way for me to assemble these parts were:

    • Insert needle into gold-colored cylinder.

    • Insert retaining clip on top of needle.

    • Then compress and insert the spring (see following steps on how the spring was inserted).

  3. Suzuki FA50 Moped Throttle Cable Teardown: passo 3, immagine 1 di 1
    • The throttle cable without any parts.

    • The round, gray top screws into the carburetor.

  4. Suzuki FA50 Moped Throttle Cable Teardown: passo 4, immagine 1 di 1
    • To assemble the throttle cable:

    • I first use a pair of needle-nose pliers to compress the spring as much as I can.

    • This allows me to insert the throttle cable into the gold-colored cylinder without having to meddle with the spring too much.

  5. Suzuki FA50 Moped Throttle Cable Teardown: passo 5, immagine 1 di 2 Suzuki FA50 Moped Throttle Cable Teardown: passo 5, immagine 2 di 2
    • I attach the throttle cable to the bottom of the gold cylinder and then route it through the cylinder's side slot.

    • The alternate view (picture 2) shows how everything looks internally.

    • After the throttle cable is in place, I let go of the spring into the cylinder.

  6. Suzuki FA50 Moped Throttle Cable Teardown: passo 6, immagine 1 di 2 Suzuki FA50 Moped Throttle Cable Teardown: passo 6, immagine 2 di 2
    • I'm simulating screwing on the throttle to the carburetor by compressing the gold cylinder against the gray cap. As you can see, the spring compresses, and the throttle cable pops outward.

    • When I twist the moped's throttle, the throttle cable goes inwards. I believe this is the desired action for the cable.

    • There are two problems, however:

    • Nothing pushes the throttle cable back out when I release the moped's throttle.

    • The throttle needle does not move, but to my understanding it should go upward when I apply the throttle.

    • Please check out my Answers question if you can help me solve this problem! Thanks a lot!

2 Commenti

which way does you set the throttle when you put it in

ladell - Replica

It appears to be correctly assembled however the cable isn't bottomed out on the cup to allow for free movement, I think you may have put a flat spot in to the cable itself that's not allowing the cup to bottom out on it and giving you the return movement.

Ken James - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 3

Ultimi 7 Giorni: 11

Ultimi 30 Giorni: 45

Tutti i Tempi: 12,872