Introduzione

I am first of all doing this to enter to win a PS3 Slim or PSP Go. I am also doing this to find out what's inside this CD player.

Questo smontaggio non è una guida di riparazione. Per riparare il tuo Sony CD Walkman D-NF430, usa il nostro manuale di assistenza.

  1. Start by looking at the fine detail of the exterior.
    • Start by looking at the fine detail of the exterior.

    Aggiungi Commento

  2. Open it, remove any CDs and put away. Open the battery cover and remove the battery.
    • Open it, remove any CDs and put away. Open the battery cover and remove the battery.

    Ohh, Black Album.

    Chris Green - Replica

    • Close the battery cover and locate your screwdriver.

    Aggiungi Commento

    • Unscrew the six screws and place them on the magnet so you'll be able to find them later. Sony was nice enough to put the screws next to the lid at an angle so you can fit a screwdriver in there.

    Aggiungi Commento

    • Insert the tip of a screwdriver between the white upper layer and the gray lower layer. Carefully pry apart. There are small clips that help hold the two layers together and you don't want to snap them.

    Aggiungi Commento

  3. Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    • Here's the inside of the bottom layer.

    Aggiungi Commento

    • Now to remove the laser reading assembly. Carefully peel the orange data ribbon off the circuit board to the plug. Using the flat screwdriver, pry the black clip away from the tan part.

    Aggiungi Commento

    • Now for the power wires. Pry up on the side opposite of the wires.

    Aggiungi Commento

    • Now for the other side. Carefully peel up the antenna plate so you can get at the other data ribbon.

    Aggiungi Commento

    • Peel the black tape off the plug. Pry up with a screwdriver on the brown clip and remove the data ribbon.

    Aggiungi Commento

    • Now for the top layer. unscrew the five screws and place them on the magnet. Pry up on the side indicated to remove the cover.

    Aggiungi Commento

    • Pull out the circuit board and LCD screen assembly. Pry up on the brown clip to remove the LCD screen.

    Aggiungi Commento

    • Now you can remove the data ribbon by prying up on the brown clip.

    Aggiungi Commento

    • To remove the buttons, carefully pry up around the little pins and pull up.

    Aggiungi Commento

    • You're done! You have taken this CD player apart and broken it down into its individual components. Now to put it back together.

    Aggiungi Commento

reuse2009

Membro da: 22/10/2009

91 Reputazione

1 Guida realizzata

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 11

Ultimi 30 Giorni: 44

Tutti i Tempi: 13,106