In today's teardown, we will be cracking open the white plastic dock that came with the Original iPhone. The dock works only with the original iPhone. However, by removing the top cover of the dock, you can use the dock with other Apple products that have a 30 pin connector. In this teardown, you can modify the dock to be universal.


Questo smontaggio non è una guida di riparazione. Per riparare il tuo iPhone 1st Generation Dock, usa il nostro manuale di assistenza.

The Original iPhone dock!
  • The Original iPhone dock!

  • This dock only holds the original iPhone. It will not hold the iPhone 3G/3GS as it is wider and thicker.

Aggiungi Commento

Use a hair dryer or heat gun to weaken the adhesive holding the rubber foot to the dock.
  • Use a hair dryer or heat gun to weaken the adhesive holding the rubber foot to the dock.

  • Use a razor blade or flathead screwdriver to pull up part of the rubber foot.

  • While still hot, pull the rubber foot off the dock.

Aggiungi Commento

  • Using a spudger or a flat head screwdriver, release the 6 clips holding the dock to the white plastic molding.

    • You will need to pry this out as the dock contains a weight that is stuck to the top casing with adhesive.

Aggiungi Commento

  • Heat up the adhesive that covers the three screws, so you can unscrew the screws that hold the weight in the base of the dock.

Aggiungi Commento

  • Remove the 3 screws holding the weight to the bottom plate.

Aggiungi Commento

  • The dock should look like this.

  • If not, go back and see what you did wrong.

Aggiungi Commento

  • Now remove the green logic board from the little plastic pegs on the bottom plate.

  • There is one peg under each black foam padding.

Aggiungi Commento

  • The little white things are the pegs.

  • Gently use a spudger or flathead screwdriver to pry the logic board from the bottom plate.

    • Be very careful, as you could break the board doing this.

Aggiungi Commento

  • Once done separating the logic board from the bottom plate, you should have 2 parts.

Aggiungi Commento

  • Disassembly is now complete. You will have five separate parts as shown in the picture.

Aggiungi Commento

  • Boom! Your done. It took me 32 minutes to figure this out with out damaging the dock.

  • I can do it in 3 minutes now that I've mastered the process.

  • If you don't replace the white top cover of the dock when reassembling, you will have a universal dock, that can also be used with an iPhone 3G/3GS.

    • It will also work with any iPod with a 30 pin connector.

Aggiungi Commento

Nicholas Ouimet

Membro da: 16/10/2009

2.091 Reputazione

9 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 11

Ultimi 30 Giorni: 65

Tutti i Tempi: 29,135