Salta al contenuto principale

Questo smontaggio non è una guida di riparazione. Per riparare il tuo Korg Volca Mix, usa il nostro manuale di assistenza.

  1. Korg Volca Mix Teardown, Remove the PCBs from the case: passo 1, immagine 1 di 3 Korg Volca Mix Teardown, Remove the PCBs from the case: passo 1, immagine 2 di 3 Korg Volca Mix Teardown, Remove the PCBs from the case: passo 1, immagine 3 di 3
    • Remove eight screws.

    • Remove the bottom plastic case. You will see the PCB.

    • Remove four further screws and unlatch the two loudspeaker-jacks.

    • Remove the three Hi/Lo-Cut knobs and the three fadercaps. You can now remove the PCB from the case.

  2. Korg Volca Mix Teardown, The Top Side: passo 2, immagine 1 di 1
    • Texas Instruments - TPS54231 2A, 28V-Input Step-Down DC/DC-Converter.

    • Texas Instruments - CD4013B D-Flipflop. I am not sure if this is correct. The Marking is CM013B/77K G4/A32G

    • National Semiconductor - LM386 Low Voltage Audio Power Amplifier

    • ST Microelectonics - STM32F030F4 Microcontroller.

    • JRC - NJM4556A Dual High-Current Operational Amplifier

    • ST Microelectronics - TL084CDT JFET Quad Operational Amplifier

  3. Korg Volca Mix Teardown, The Bottom Side: passo 3, immagine 1 di 1
    • Texas Instruments - CD4013 D-Flipflop

    • ST Microelectronics - LT084CDT JFET Quad Operational Amplifier

Christian

Membro da: 03/09/14

1.510 Reputazione

8 Guide realizzate

Un commento

thank's for this guide

Skander BEN M'RAD - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 8

Ultimi 30 Giorni: 26

Tutti i Tempi: 975