The Dell latitude D620 was introduced in March 2006. Both the first MacBook Pro and this Dell Latitude D620 have the same Intel Core Duo T2300E. Like the first MacBook, they both have Intel's GMA 950 Integrated Graphics.

Questo smontaggio non è una guida di riparazione. Per riparare il tuo Dell Latitude D620, usa il nostro manuale di assistenza.

  1. Open the laptop's screen 180 Degrees so it is straight back.
    • Open the laptop's screen 180 Degrees so it is straight back.

    • Use a flat head screwdriver or a spudger to pry the top bezel off. WOrk it side to side until the bezel is freed from the chassis, exposing 3 screws

    Aggiungi Commento

  2. Remove the 3 Phillips screws securing the keyboard.
    • Remove the 3 Phillips screws securing the keyboard.

      • Just remember to keep your screws organized! It will make everything much easier.

    Aggiungi Commento

    • Use your fingers to carefully lift up the keyboard. Refer to the first picture for guidance.

    • Carefully pull the keyboard upwards toward the LCD screen so it can be released from the bottom tabs.

    • Carefully lift the keyboard so the keys are resting on the palmrest, this will expose the ribbons for the keyboard, trackpad and Tracking Nub.

    Aggiungi Commento

    • Insert a small flat head screwdriver or a spudger into the small notch in between holding down the ribbon.

    • Grab the metal bar on top of the keyboard connector and pull straight up. The cable should come free.

    Aggiungi Commento

    • Grab the top of the display connector and pull it straight up and out.

      • This connector requires a little more force than the others, so it may take some effort.

    Aggiungi Commento

    • Use a tool or your fingers to gently remove the antenna cables from the wireless card.

    Aggiungi Commento

    • Pull back the clips by the antenna connectors, and the card should rise up on its own. Gently remove the card from its socket.

    Aggiungi Commento

    • Not all devices have a WWAN Card, so most people can skip this step.

    • Using similar procedures as the WLAN, disconnect the single antenna cable, push the rear clips back and remove the card.

    Aggiungi Commento

    • Close the laptop screen completely, make sure it clips in place.

      • Make sure no cables or parts get caught in the hinge.

    • The bottom screw is labeled with D, remove it.

    • The screw on the rear is not labeled, remove it as well.

      • Rinse and repeat for both sides of the laptop.

    Bad writing. Make sure not to bind the cables or damage. . . .

    David Matchen - Replica

    • Very, VERY carefully open up the screen so it is at a 90° angle with the palmrest.

    • Pull it straight up, making sure all cables are free of their routing ares.

    Aggiungi Commento

    • Remove all of the remaining screws on the laptop with a Phillips screwdriver.

    • There are screws on the top under the keyboard as well, remove those.

      • All of the screws with a P by them means they secure the palmrest. This will help you keep organized.

    Aggiungi Commento

    • Seperate the palmrest from the device, starting from the back by sliding it forward and pulling it most of the way off.

      • Don't remove it completely, there is still one connector attached.

    Aggiungi Commento

    • Pull the trackpad connector straight out of the motherboard.

      • Don't pull on it by the cables, grab as close to the socket as you can.

    Aggiungi Commento

    • With a Phillips screwdriver, remove the 4 screws on the heatsink, in order of the numbers of the metal.

      • Loosening the screws out of order can be damaging.

    Aggiungi Commento

    • Grab the heatsink and remove it, it may require force.

    • There is still thermal paste and a thermal pad attached.

    Aggiungi Commento

    • Clean the remaining thermal compound off of the CPU. Remove the thermal pad if it is still stuck to the GPU.

    Aggiungi Commento

    • Several more photos of the Intel Core Duo.

    Aggiungi Commento

    • Gently turn the screw above the socket and lift the CPU out.

      • The End!

    Wow, great pictures from a cell, I thought you were using a digital camera like a kodak or something

    Skippy722 - Replica

    The Link to is returning a 404

    I found a copy on at:

    Tim downing - Replica

Nicholas Ouimet

Membro da: 16/10/2009

2.119 Reputazione

7 Guide realizzate

Seems like it would make a perfect "Hackintosh."

Chris Green - Replica

Citazione da Chris Green:

Seems like it would make a perfect "Hackintosh."

Yes. It does indeed. I've been using it as a hackintosh sense early February. I had Mac OSX 10.6.2 on it, even before I performed this tear down. I was able to use software updater to go strait from 10.6.0 to 10.6.2. Skipping 10.6.1. I've only had a few kernel panics. I've even been using the iPhone SDK. It is a very stable hackintosh. The GMA 950 can even play The SIms 3 w/o any issues.

Nicholas Ouimet - Replica

Fantastic guide!! Thank you for taking the time and effort to create it!

Steve Weinrich - Replica

There is a little flat, white, Multi-wire connector in the upper-left corner.

I suspect that this is where the optional Bluetooth module would be located, can anyone confirm this?


Tim D.

Tim downing - Replica

Yes, the flat white connector on the left side above the keyboard is for the optional bluetooth connector. It interfaces via USB.

souta95 -

Nice guide! I just resurrected an old D620 that was on the pile, that I occasionally use for one piece of ancient code. I've disassembled, aired out the dust, and cleaned it. Replaced the non-functioning Dell battery with an OMCreate aftermarket battery.

This is a Core 2 Duo 2.3 GHz. Upgraded the HDD to a Hitatchi 320 GB SATA3 that was sitting here. Even though the D620 only has a SATA1 interface, might pick up a SSD, just to give it some more life. I did a clean install of Win7x64 bit + SP & patches (Nov2016), used the Dell's Vista nVidia NVS 110 video driver (File = R142931), installed and worked great.

I went ahead and ordered a replacement keyboard, since it has some sticky keys & a missing key cap. Also 2 x 2GB SODIMMs. That should give new life to this 10 year old notebook and keep it out of the landfill for at least another 4-10 years.

Thanks Nicholas & iFixit for the inspiration!

Michael Erwin - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 3

Ultimi 7 Giorni: 31

Ultimi 30 Giorni: 123

Tutti i Tempi: 63,112