Salta al contenuto principale

Strumenti necessari in questo Smontaggio

Introduzione

This is an easy-to-teardown device and shows you the inner workings of the label maker. The main components are batteries and the label cartridge for the tape, and a few screws to further tear down the device.

Questo smontaggio non è una guida di riparazione. Per riparare il tuo Brother PT-90 Personal Labeler, usa il nostro manuale di assistenza.

  1. Start with your device off. The screen should be blank and not displaying anything. Turn the device over so it's resting face down.
    • Start with your device off. The screen should be blank and not displaying anything.

    • Turn the device over so it's resting face down.

    • You should be able to see the model name of the label-maker, as well as a window in which you can view the label cartridge.

  2. Using your thumb, press in and then upward on the fastener at the top of the device. The back of the device should come off easily. Remove the 4 batteries located on the left side of the device. Remove the 4 batteries located on the left side of the device.
    • Using your thumb, press in and then upward on the fastener at the top of the device. The back of the device should come off easily.

    • Remove the 4 batteries located on the left side of the device.

  3. Kit riparazione batterie MacBook

    A partire da $69.99

    Buy Now

    Kit riparazione batterie MacBook

    A partire da $69.99

    Buy Now
  4. To remove the label cartridge from the device, use a plastic opening tool from your iFixit tool kit. To remove the label cartridge from the device, use a plastic opening tool from your iFixit tool kit. To remove the label cartridge from the device, use a plastic opening tool from your iFixit tool kit.
    • To remove the label cartridge from the device, use a plastic opening tool from your iFixit tool kit.

  5. Attach the J1 Screwdriver Bit to the extension tool from your tool kit. Remove all of the screws from the back of the device. Remove all of the screws from the back of the device.
    • Attach the J1 Screwdriver Bit to the extension tool from your tool kit.

    • Remove all of the screws from the back of the device.

  6. Once the screws have been removed, press as shown on the fastener. Carefully open the device.
    • Once the screws have been removed, press as shown on the fastener.

    • Carefully open the device.

Tessa Hathaway

Membro da: 13/10/2016

127 Reputazione

1 Guida realizzata

Team

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 274