Salta al contenuto principale

Parti

Nessuna parte specificata.

    • I grab this video from Youtube, its show very clear how to open the top and the back panel. Please watch until 2min

  1. Unscrew the white box cover in the back, 4 screws. Remove the white box cover, and then careful lift the electronic board as the picture
    • Unscrew the white box cover in the back, 4 screws.

    • Remove the white box cover, and then careful lift the electronic board as the picture

    • Look for two line, one white and one black on the bottom. They should be connect to the electronic board through 2 connectors

    • Cut that two lines

  2. Kit di riparazione batterie iPhone

    Solo $29.99

    Buy Now

    Kit di riparazione batterie iPhone

    Solo $29.99

    Buy Now
  3. Unscrew and take out the dial Take out the outer burr
    • Unscrew and take out the dial

    • Take out the outer burr

    • Unscrew 4 screws

    • Take out the motor

  4. Unscrew 4 screws Carefull lift the part with motor up.
    • Unscrew 4 screws

    • Carefull lift the part with motor up.

  5. Examine the gear. In my case, I found one strange object, sticked on the gear wall. Look like it is a washer pressed with gear teethes. Good to take it out but I wonder where it came from? In my case, I found one strange object, sticked on the gear wall. Look like it is a washer pressed with gear teethes. Good to take it out but I wonder where it came from?
    • Examine the gear.

    • In my case, I found one strange object, sticked on the gear wall. Look like it is a washer pressed with gear teethes. Good to take it out but I wonder where it came from?

  6. Unscrew this, remember follow the clock wise If you just want to replace worn out impeller: hold the limiter steady, unscrew (red square) with clock wise, take out the inner burr. And try to clean and replace the impeller while holding the limiter! You should ask some body to help with this step. Take the Limiter out. Take care because it go with 6 balls and 6 springs! Perform this step only if you think there are some wrong with the Limiter (Big crack sound when grind )
    • Unscrew this, remember follow the clock wise

    • If you just want to replace worn out impeller: hold the limiter steady, unscrew (red square) with clock wise, take out the inner burr. And try to clean and replace the impeller while holding the limiter! You should ask some body to help with this step.

    • Take the Limiter out. Take care because it go with 6 balls and 6 springs! Perform this step only if you think there are some wrong with the Limiter (Big crack sound when grind )

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

thanhlp

Membro da: 11/07/2018

193 Reputazione

1 Guida realizzata

Hi, could you please tell me from where can I buy Breville BCG820BSS1BCA1 gear/limiter, the one which is in step 6. it’ll be big help.

my email is hbk.singhvi@gmail.com

sandeep singhvi - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 3

Ultimi 7 Giorni: 8

Ultimi 30 Giorni: 25

Tutti i Tempi: 227