Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Strumenti necessari in questo Smontaggio

Questo smontaggio non è una guida di riparazione. Per riparare il tuo AVerMedia GL310, usa il nostro manuale di assistenza.

  1. Use a spudger to lift the corners of the silicone membrane under the device. Unscrew the Phillips head screws using a PH000 screw bit.
    • Use a spudger to lift the corners of the silicone membrane under the device.

    • Unscrew the Phillips head screws using a PH000 screw bit.

  2. Lift up the backplate.
    • Lift up the backplate.

  3. Insert a plastic spudger into the highlighted notch in the motherboard. Remember to use a plastic spudger or els you may short the solder joints near the notch. Pull the motherboard up using the spudger.
    • Insert a plastic spudger into the highlighted notch in the motherboard.

    • Remember to use a plastic spudger or els you may short the solder joints near the notch.

    • Pull the motherboard up using the spudger.

    • Remove the motherboard, holding the corners.

  4. Here's a list of chips present on the motherboard: ITE IT6613 HDMI transmitter
    • Here's a list of chips present on the motherboard:

    • ITE IT6613 HDMI transmitter

    • ITE IT6604 single-link HDMI 1.4 receiver

    • Nanya NT6DM16M32BC-T1 mobile 512mb DDR RAM chip clocked at 200MHz

    • Sigma Designs PL330B-CPE3 H.264 Encoder

    • This seems to be the same chip found on the C875 model of the device

    • Texas Instruments LVC244A octal buffer/ driver

    • Nuvoton NUC100RD2BN RISC ARM microcontroller clocked at 50MHz

Marcus Jones

Membro da: 22/11/2018

545 Reputazione

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 14

Ultimi 30 Giorni: 72

Tutti i Tempi: 200