Salta al contenuto principale

Questo smontaggio è in corso – Ricarica periodicamente per vedere gli ultimi cambiamenti!

Strumenti necessari in questo Smontaggio

  1. Flip the unit upside down to access the six screws on the bottom.
    • Flip the unit upside down to access the six screws on the bottom.

    • Remove the six screws indicated with a Phillips-head screwdriver. All the screws are of the same length.

  2. Turn the unit back over, and pull the top half up and away from the device.
    • Turn the unit back over, and pull the top half up and away from the device.

  3. Unplug the laser assembly's power cable and ribbon cable from the main board.
    • Unplug the laser assembly's power cable and ribbon cable from the main board.

    • Remove the two screws on the memory card/controller port, disconnect the ribbon cable, and lift it out of the case.

  4. To remove the power supply, disconnect the cable and remove the two screws, then lift it out of the case. To remove the power supply, disconnect the cable and remove the two screws, then lift it out of the case.
    • To remove the power supply, disconnect the cable and remove the two screws, then lift it out of the case.

  5. Remove the 3 screws from the shield. Remove the 3 screws from the shield.
    • Remove the 3 screws from the shield.

  6. Kit di riparazione per Android

    A new screen or battery is one kit away.

    Acquista ora

    Kit di riparazione per Android

    A new screen or battery is one kit away.

    Acquista ora
  7. Remove the 5 Phillips screws. You can now lift the main board out of the case.
    • Remove the 5 Phillips screws.

    • You can now lift the main board out of the case.

  8. Lift the RF shield out of the case. Lift the RF shield out of the case.
    • Lift the RF shield out of the case.

  9. Reinstall the RF shield by dropping it in and lining up the slots and tabs. Reinstall the RF shield by dropping it in and lining up the slots and tabs.
    • Reinstall the RF shield by dropping it in and lining up the slots and tabs.

  10. Replace the main board.  Only install the screws indicated in red. Replace the main board.  Only install the screws indicated in red.
    • Replace the main board. Only install the screws indicated in red.

  11. Replace the top shield, and secure with the 3 screws indicated.
    • Replace the top shield, and secure with the 3 screws indicated.

    • Reinstall the memory card / controller module. Connect the ribbon cable and replace the 2 screws.

  12. Align the optical drive assembly with the three pegs.
    • Align the optical drive assembly with the three pegs.

    • Reconnect the power and data cables for the optical drive.

  13. Slide the cover on the system in the same way you took it off and replace the black screws indicated.
    • Slide the cover on the system in the same way you took it off and replace the black screws indicated.

  14. Plug in the console and turn it on.
    • Plug in the console and turn it on.

    • Thanks for looking at my teardown!

Nick

Membro da: 10/11/2009

50.754 Reputazione

39 Guide realizzate

Team

Master Techs Membro di Master Techs

Community

290 Membri

822 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 8

Ultimi 30 Giorni: 34

Tutti i Tempi: 40,909