Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Guide per la versione Wi-Fi dell'iPad Mini 2. Annunciato il 22 ottobre e introdotto il 12 novembre 2013. L'iPad mini 2, noto anche come iPad mini con Retina Display, ha tutti i pixel dell'iPad Air in un più piccolo fattore di forma da 7,9"

201 Domande Visualizza tutte

What tools do I need for repairing fpc connector

Hey All,

I was wondering if someone here could help me get started with microsoldering and help me find the tools I need. I have been able to get my on a lot of ipads and iPhones which couldn't be fixed in a center (they didn't do soldering repairs) so I want to experiment with them.

Any help will be greatly appreciated

Rispondi a questa domanda Anch'io ho questo problema

Questa è una buona domanda?

Punteggio 0
Aggiungi un commento

SKIP THE UPGRADE

Save by fixing with an all-in-one kit.

Shop iPhone Fix Kits

SKIP THE UPGRADE

Save by fixing with an all-in-one kit.

Shop iPhone Fix Kits

1 Risposta

I assume this is the digitizer FPC touch screen connector right?

You’ll need the following:

  • Soldering iron
  • Fine pointed tweezers for pick up and placement of the old/new FPC connector
  • Solder wire (leaded of course is always better, non leaded has a higher melting point making it harder to use)
  • Hot air rework station: A good quality one goes a long way, the cheap ones may not provide enough heat or constant temperature to remove the old FPC connector quickly and easily.
  • Flux: AMtech NC559-V2-TF (doesn’t have to be exact there are similar models that are good) is what I use. Cheap flux may not let the solder flow well with solder joints, pads or connectors and can increase the chances of solder bridging.
  • Solder Wick: To remove old solder mostly for non-leaded solder to put in place leaded solder.

Note that the FPC connector is quite fragile where some pins may break off when unplugging the digitizer ribbon cable. To avoid this always unplug from the shorter end with nail or a flat rigid spudger (nylon plastic types will do).

Questa risposta è stata utile?

Punteggio 0

Commenti:

@benjamen50

Yea indeed.

Do you have any suggestions for a decent soldering station and m hot air station?

Thank you for your help

da

Quick 861DW for Hot Air Station and Hakko FX-951 these are quite expensive options there may be cheaper alternatives.

da

Aggiungi un commento

Aggiungi la tua risposta

Jochem Luytens sarà eternamente grato.
Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 4

Tutti i Tempi: 26