Loop mode after changing battery

Question

iPhone 7

Rilasciato il 16 settembre 2016. Modello 1660, 1778. Disponibile come GSM o CDMA / 32, 128 o 256 GB / Rose gold, gold, silver, black e jet black.

2264 Domande Visualizza tutte

CHRISTRUSCH88 @chris8585

Rep: 1

Postato: 3 dic 2019

Opzioni

Loop mode after changing battery

Replaced my iPhone 7 battery yesterday. I’ve done this in the past with my old iPhone so I felt fairly confident. Followed directions and all seemed to go smooth. When powered back on, my phone is stuck in loop mode and won’t fully start up. Rechecked all my cables and all seem fine. After further investigation I realized my phone would fully start up and work if I left the home button cable unplugged. Home button obviously doesn’t work, but everything else works fine. Any ideas what my issue may be??

Rispondi a questa domanda Anch'io ho questo problema

Questa è una buona domanda?

Sì No

Punteggio 0

1 Commento

My phone charges up and works fine without the shorter home button cable plugged in (other than not having a home button). I’m actually using it right now. It just won’t start up when home button is hooked up. Does this point to an issue with the home button or is it possible that it will boot up if I leave it in loop mode for a while?

4 dic 2019 da CHRISTRUSCH88

Aggiungi un commento

2 Risposte

My phone charges up and works fine without the shorter home button cable plugged in (other than not having a home button). I’m actually using it right now. It just won’t start up when home button is hooked up. Does this point to an issue with the home button or is it possible that it will boot up if I leave it in loop mode for a while? — CHRISTRUSCH88

Ben @benjamen50 Rep: 159,7k Mtwo Perform 11 191 368 · Answer 1 · 2019-12-03T22:40:32-07:00

Risposta Più Utile

Ben @benjamen50

Rep: 159,7k

Mtwo Perform

11

191

368

Postato: 3 dic 2019

Opzioni

From your case it would be either one of the following:

The home button flex cable on the home button itself has been torn. Extremely unlikely if the metal bracket for the home button was not removed from the screen.

The most likely cause is a microtear on the screen cable itself. It'll be the smaller cable specifically coming from the screen and not the front camera.

The part where it tears is behind the metal shield that goes on top of the back of the screen.

Hopefully just the screen needs to be replaced rather than the home button which if it is the latter would required to be replaced by an aftermarket one with no touch ID.

Questa risposta è stata utile?

Sì No

Punteggio 1

1 Commento:

Ben is right. This is a common problem after removing and replacing the screen. If you leave it long enough it should boot and you can confirm.

4 dic 2019 da Chris Stables

Aggiungi un commento