No spark on 2&3 cylinder
I have a good 12v power and ground at the coil but no pulse.
Questa è una buona domanda?
Punteggio
0
597974
3 Risposte
Rep: 815,1k
1,2k
921
2,4k
@smitty9448 If the coil is new, teh wires new and you still have no spark I would suggest you check the wire on connector to your coil to see if you get a signal. You will need a tester that can measure hertz. It is the fuel injection computer that triggers the signal to your coil.
Questa risposta è stata utile?
Punteggio
0
Rep: 871
3
The hertz inspection is good but I believe on this engine that the Cam Position Sensor signal will be fluctuating from a strong signal to a weak signal as the camshaft bore is probably worn out due to lack of proper maintenance and oil changes. This will show up on a signal trace via an oscilloscope.
Questa risposta è stata utile?
Punteggio
0
bad Cam Position Sensor or shaft sensor
Questa risposta è stata utile?
Punteggio
0
Have you tried changing out the spark plugs
da Noah
@smitty9448 1.6 or 2.0 engine?
da oldturkey03
Yes i have even changed the coil.
da John Smith
Yes it is a 2.0
da John Smith
Just to verify, cylinder 1 and 4 have spark but not 2 and 3? You replaced the coil for 2&3? Do you have a meter that can test Hertz? you replaced the plug wires as well?
da oldturkey03
Mostra 1 altro commento