High Fan RPM and No Airport Hardware Found

It is quite obvious: The cable connects camera and airport card to the logic board. I'm not shure but i think there is even a themp. senor for the LCD - if that can't be read the fans will ramp up.

Judging from your pictures you might still have a chance to connect the cable and secure it afterwards with thermal resistant tape such as kapton.

Questa risposta è stata utile?

Sì No

Punteggio 2

2 Commenti:

Hi remacberlin

I tried to conect the connector and fits well but i think that any pin is damaged.

One question, above the connector have a padded sticker, this is necessary to works the connector?

27 lug 2011 da Juan Ramos Martinez

You can leave the pad off, no problem. Try (very carefully) to correct the bent pin with a needle or similar.

27 lug 2011 da remacberlin

Aggiungi un commento

Hi remacberlin

I tried to conect the connector and fits well but i think that any pin is damaged.

One question, above the connector have a padded sticker, this is necessary to works the connector? — Juan Ramos Martinez
You can leave the pad off, no problem. Try (very carefully) to correct the bent pin with a needle or similar. — remacberlin