Salta al contenuto principale

Unit will drain, but only for about 6-7 seconds, then cont. to wash

My washer begins it’s cycle, then it drains partially, then continues with its cycle. This caused an accumulation of water in the tub to the point where the unit is half full of water.

Update (08/06/2019)

I am afraid to put in a new pump because the pump is working, just will not run until the tub is empty.

Update (08/06/2019)

This unit is a LG model # - WM3180CW

Rispondi a questa domanda Anch'io ho questo problema

Questa è una buona domanda?

Punteggio 0
Aggiungi un commento

1 Risposta

Does your machine start as soon as the pump stops? If so then you pump is fine and you may have a water level sensor out of place or defective, worse case is the control board.

Questa risposta è stata utile?

Punteggio 0

1 Commento:

Yes. When I turn on machine and select a cycle, the unit starts by draining for about 6-7 seconds. Then it begins the cycle. Could it possibly be a pressure switch?

da

Aggiungi un commento

Aggiungi la tua risposta

Ray sarà eternamente grato.
Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 36