Aggiusta la tua roba Comunità Store

L'aggiornamento di marzo 2015 del MacBook Air 13" di Apple ha processori di quinta generazione Intel Core i5 e i7, risultando in una migliore performance e maggiore vita della batteria.

623 Domande Visualizza tutte

Opzioni

Pulled lcd connector pad

Block Image

Block Image

Block Image

Hey,

i had had a water damage Macbook come in for repair. I took the LCD Connector off because I noticed it was burnt on the right side of the logic board.

anyways, I pulled the connector off and noticed a pad was gone. I looked at the trace for it and it looks like the last pin is on the same circuit. Can some chime in to tell me if I could solder the pin over to that one? And possibly provide a schematic of this connector so I know what it does

Risposto! Visualizza la risposta Anch'io ho questo problema

Questa è una buona domanda?

Sì No
Punteggio 0
Aggiungi un commento

1 Risposta

Filtra per:
Più utili Più recenti Più Vecchio
Soluzione Prescelta

Opzioni

Actually, it looks like the pad is not connected to anything, at least not on the surface. Perhaps that’s just because the picture isn’t zoomed in enough.

As for the schematic, you have to provide the logic board model number otherwise we’re just guessing.

EDIT

Block Image

Questa risposta è stata utile?

Sì No
Punteggio 2

5 Commenti:

Sorry I desoldered the connector and seen the pad was pulled. I’m curious to know if that pad is ground or not needed for anything

da

This logic board is for MacBook Air 13” early 2015

da

I meant to say "pad" and not "connector" (see edit above).

What is the logic board model number (820-XXXX-X), you will see it silk screened on the pcb.

da

I updated my question with the board pictures . I couldn’t see 820 anywhere on the board

da

It's pin 2, NC as I suspected.

da

Aggiungi un commento

Aggiungi la tua risposta

Daniel Ringuette sarà eternamente grato.
Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 81