Aggiusta la tua roba Comunità Store

Rilasciato il 19 settembre 2014, è la versione con schermo più grande (5.5") dell'iPhone 6.

1525 Domande Visualizza tutte

Opzioni

iPhone 6 Plus Error 4013 after Screen, Logic, and Lightning replaced

I recently gained possession of an iPhone 6 Plus that I replaced the screen on for a friend. The phone then proceeded to boot loop until it ran out of power. Thinking that the device was fubar, he gave it to me. So I decided to try basically everything. Got to the point that I decided to replace the logic board after having heard that error 4013 can be NAND related. Did that. Still get the exact same error whenever I try to restore it with iTunes.

64GB AT&T Locked iPhone 6 Plus

Parts replaced:

  • Screen
  • Lightning and audio assembly
  • Logic Board
  • 5GHz wireless antenna

Any insight?

Rispondi a questa domanda Anch'io ho questo problema

Questa è una buona domanda?

Sì No
Punteggio 0
Aggiungi un commento

2 Risposte

Filtra per:
Più utili Più recenti Più Vecchio
Risposta Più Utile

Opzioni

disconnect everything except chargeport and see if it will flash without errors, then if it goes through ok start connecting each component one at a time until you find the culprit.

Questa risposta è stata utile?

Sì No
Punteggio 1

3 Commenti:

well... seems like the screen was the problem, but that raises a new question... how come a screen that was purchased from iFixit didn't let the phone boot or restore...

da

So, that "fixed" it, but now it just boot loops forever again... And I can't test the original screen anymore because it was practically unusable when I replaced it.

da

Bad front camera or home button flex from a screen that has preassembled components can cause this.

da

Aggiungi un commento

Opzioni

That is Nand issues,Most of the cases you have to reprogram Nand with removing from logic board and reprogram with programmer.

Questa risposta è stata utile?

Sì No
Punteggio 0

1 Commento:

The logic board has already been replaced with a known good board. So the issue is no longer NAND related. Also, I was able to get it restored by taking the replaced screen off. So the issue is now with the screen and that it causes a boot loop whenever it’s connected.

da

Aggiungi un commento

Aggiungi la tua risposta

John Peters sarà eternamente grato.
Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 73