Rep: 3,4k
12
11
3
Hi,
what temperature should i use to solder the pins on the LCD-connector (1). The former owner pulled a little bit to hard, now some of the pins are...lets say disconnected.
I use a WELLER EC 2002 with a very fine tip and i already looked for a new LCD. So why shouldn´t i try to solder it, its ruined anyway.
Questa è una buona domanda?
Rep: 3,4k
12
11
3
I wanted to solder the connector back to the cable of the LCD. I've tried it with 320°C but that didn't worked. A day later the new LCD arrived so i didn't tried it anymore.
Questa risposta è stata utile?
The temperature has to be above 320°C...just to get it off the unanswered list.
thanks
I am not clear on what you are soldering. The connector that the LCD plugs into on the logic board?
Questa risposta è stata utile?
spam
Questa risposta è stata utile?
all your answers are just links to a pay service...
Ultime 24 Ore: 0
Ultimi 7 Giorni: 0
Ultimi 30 Giorni: 0
Tutti i Tempi: 4,466
1 Commento
If one of these answers fixed your problem please hit the "accept" in list that has "History Edit Flag Accept Comment" located to the upper right of your question so we can remove it from the unanswered list. Thanks.
da mayer