Aggiusta la tua roba Comunità Store

iPhone con schermo da 4" introdotto nel marzo 2016 con specifiche hardware simili a quelle dell'6s. Disponibile in Argento, Oro, Grigio siderale, Oro rosa con 16 o 64 GB. Modelli A1662 e A1723.

1049 Domande Visualizza tutte

Opzioni

u4020 critical to boot?

Good afternoon,

I'm just researching a water damaged iPhone SE that initially had a VCC_Main shorted that was alleviated by removing one cap.

When connecting to power now, it draws 0.43mA / 0.44mA and U4020 LED Driver gets really hot (freeze spray used to detect).

It controls the "LED Driver" and schematics says it is critical. Is it critical for boot? or if we remove this should we be able to artificially use a light and go into the screen layers?

Risposto! Visualizza la risposta Anch'io ho questo problema

Questa è una buona domanda?

Sì No
Punteggio 0
Aggiungi un commento

1 Risposta

Filtra per:
Più utili Più recenti Più Vecchio
Soluzione Prescelta

Opzioni

Just to confirm, U4020 is not Stockholm but the Backlight Driver IC. A damaged or defective backlight driver doesn’t stop the phone from booting, unless it is pulling down PP_VCC_MAIN. So check VCC_MAIN to see if it is short or or not giving the proper voltage.

Obviously, a missing backlight driver doesn’t affect the boot either.

You should also probe the backlight circuit as if U4020 is hot, then one of the caps may be shorted on the output side.

Questa risposta è stata utile?

Sì No
Punteggio 3

6 Commenti:

Thank you Minho, Not sure how I got this confused thinking it is Stockholm, must have had different schematics up or something. Will check the VCC_Main voltage and see

da

VCC_Main is low! 2.9V, I will remove this and see if it helps things.

da

VCC_Main short up to 3.6V now but still power being drawn is 0.45mA, no obvious signs of heat but removing this chip helped because there was a lot of corrosion, even under it!

Any ideas of probing further with this at all? I really appreciate your help!

da

What do you mean by "VCC_Main short up to 3.6V " ?

da

Using a multimeter in DC voltage mode VCC_Main is reading at 3.68V, before removing the LED Driver this was a lot lower

da

Mostra 1 altro commento

Aggiungi un commento

Aggiungi la tua risposta

Elliot sarà eternamente grato.
Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 2

Tutti i Tempi: 156