Rep: 11
1
Hi,
I’ve been a bit of an idiot and stripped the bottom two screws on the plate that goes over the screen connectors on the main board. I’ve tried rubber band and super glue and I can’t seem to put in a notch with a Stanley knife.
Does anyone have any tips to remove thes screws? It would be greatly appreciated.
Thanks
Questa è una buona domanda?
Rep: 221,4k
15
289
807
You've already tried the two most popular tricks...you could try something like this extractor set. My concern here is that if they were stripped because you previously torqued them in too hard, you may have damaged the logic board underneath the standoffs.
Questa risposta è stata utile?
That's good to know. The location of these screw limits some of the hardcore options you could try. If you can get your hands an a quality driver, that may work. Otherwise go for an extractor set.
Thanks for the response. This was a phone that’s never been repaired before, so unless it was manufacture error then I’m pretty sure it was just because I was persisting with rubbish screwdriver set. There doesn’t look to be any damage to the boards. Everything still works ok when phone is switched on.
Ultime 24 Ore: 0
Ultimi 7 Giorni: 0
Ultimi 30 Giorni: 1
Tutti i Tempi: 54
