iPhone 6s boot loop

Question

iPhone 6s

Lanciato il 25 settembre 2015. Modello A1688/A1633. Si ripara in modo simile alle generazioni precedenti, richiede cacciaviti e strumenti di apertura. Versioni GSM o CDMA /16, 32, 64, 128 GB / Oro rosa, Oro, Argento, Grigio siderale.

2687 Domande Visualizza tutte

Andre Warren Jr @andrewarren

Rep: 73

3

2

Postato: 10 mag 2017

Opzioni

iPhone 6s boot loop

I replaced the screen on my iPhone 6s and I followed to ifixit handbook and everything and when I went to power the screen on. I started getting a boot loop. I took it to a repair shop and they said they couldn't find what was wrong. I've tried all the boot loop methods online and I've tried restoring. Nothing has worked. I've been told the mother board has been fried by research and I don't understand why that's so. Nothing looks broken everything looks the way it should

Risposto! Visualizza la risposta Anch'io ho questo problema

Questa è una buona domanda?

Sì No

Punteggio 6

4 Commenti

Have you tried changing the battery?

11 mag 2017 da rayeasom

Yes.........

11 mag 2017 da Andre Warren Jr

Maybe there is a short in the LCD connector or light ic or cap

18 mag 2018 da Sharfaz

The screen that is not original can cause bootloop in this case try another screen

14 feb 2020 da hamitouche

Aggiungi un commento

2 Risposte

Soluzione Prescelta

Minho @refectio

Rep: 221,4k

Refectio - Mail-in Micro-Soldering Repairs & Data Recovery

15

289

806

Postato: 10 mag 2017

Opzioni

I know you said you tried all of the boot-loop suggestions but you don't tell us which ones. So for the record, I'll post some ideas below and tell us if there's anything in there that you haven't tried. That way we'll be able to help a you a bit more.

A few things to consider:

Try these things (if you haven't already) to see if anything helps:

Try a hard reset (Home & Power button for 10 secs)
Use a genuine Apple Lightning connector
Use a genuine Apple charging brick and let it charge overnight
Try to connect it to different computers (mac/pc if possible) with an updated iTunes
Put the phone in recovery mode (search DFU Mode). Careful, this can reset your data
Use 3uTools for putting it in and out of Recovery Mode
Use 3uTools to flash the firmware (you can't downgrade)
Check the condition of all the flexes (with magnification)
Disconnect the Front Camera Ribbon from the logic board and reboot your phone
Disconnect the screen assembly completely and see if iTunes will recognize the phone.

Otherwise, you probably have a logic board issue. If you are uncomfortable doing these steps, consider finding a repair shop that does micro-soldering; they can go deeper if the problem is not modular in nature.

Questa risposta è stata utile?

Sì No

Punteggio 8

4 Commenti:

Your answers are good as always :)

Also OP exactly how long does it stay on the apple logo then shut off and boot up again? This can tell us what areas of hardware faults we should be looking at.

10 mag 2017 da Ben

I tried the hard reset. And I just tries the disconnecting the camera. It had about a 5 minute boot loop and just sated on the black screen. Let me ask one question that might help. When I did the screen repair I didn't disconnect the battery. Could that be a problem?

11 mag 2017 da Andre Warren Jr

Not disconnecting the battery prior to the removal of the screen can certainly cause problems with the backlight circuit.

However, I would be more concerned that you may have caused Long-Screw Damage. That is when you accidentally put a long screw where a short screw would go (usually on the Display bracket). If you didn't keep track of the screws and their placements, this is a real possibility.

At this point, I would consider finding a repair shop that does micro-soldering to properly troubleshoot your phone.

11 mag 2017 da Minho

I make this tes : Disconnect the screen assembly completely and see if iTunes will recognize the phone. I itune don't detect my iphone is it normal ?

8 gen 2022 da Christopher Beaudry

Aggiungi un commento

Maybe there is a short in the LCD connector or light ic or cap — Sharfaz
The screen that is not original can cause bootloop in this case try another screen — hamitouche
Your answers are good as always :)

Also OP exactly how long does it stay on the apple logo then shut off and boot up again? This can tell us what areas of hardware faults we should be looking at. — Ben
I tried the hard reset. And I just tries the disconnecting the camera. It had about a 5 minute boot loop and just sated on the black screen. Let me ask one question that might help. When I did the screen repair I didn't disconnect the battery. Could that be a problem? — Andre Warren Jr
Not disconnecting the battery prior to the removal of the screen can certainly cause problems with the backlight circuit.

However, I would be more concerned that you may have caused Long-Screw Damage. That is when you accidentally put a long screw where a short screw would go (usually on the Display bracket). If you didn't keep track of the screws and their placements, this is a real possibility.

At this point, I would consider finding a repair shop that does micro-soldering to properly troubleshoot your phone. — Minho
I make this tes : Disconnect the screen assembly completely and see if iTunes will recognize the phone. I itune don't detect my iphone is it normal ? — Christopher Beaudry