Salta al contenuto principale

Introdotto il 19 settembre 2014, questo iPhone con schermo da 4,7" è la versione più piccola dell'iPhone 6 Plus. Identificato dai numeri modello A1549, A1586, and A1589.

4994 Domande Visualizza tutte

iPhone 6 U1700 ripped pad

Hi, I have an iPhone 6, I tried replacing U1700 Tristar and ended up ripping TRISTAR_TO_AP_JTAG_SWCLK while wicking the pads. Is this connection important? I have not tried reinstalling the chip.

Risposto! Visualizza la risposta Anch'io ho questo problema

Questa è una buona domanda?

Punteggio 0
2 Commenti

Does it go to the CPU is you click net?

da

Hmm. We can figure this out. Some of the pads are NC and might not reflect negatively on replacing the chip @refectio to the rescue

da

Aggiungi un commento

2 Risposte

Soluzione Prescelta

TRISTAR_TO_AP_JTAG_SWCLK is used to tell the JTAG interface what frequency (kHz) it should be running at when programming the U1700 chip so that when it is being programmed, the data sent to program the chip isn't been sent too fast.

TL:DR - This pad is not needed as it is used solely for programming the U1700 chip - Programmed already anyway.

Source:

JTAG_CLK explained - https://community.nxp.com/thread/329958

JTAG_CLK - http://prntscr.com/f45si0

Questa risposta è stata utile?

Punteggio 5

2 Commenti:

+1 Great answer as usual!

da

Good answer @benjamen50

da

Aggiungi un commento
Risposta Più Utile

Generally speaking, all of the connections are important. However as @benjamen50 says, this one you can live without.

Now this brings up a good point...cleaning up the board after you lift an IC. A lot of the older videos online will show "agressive" use of desoldering braid to get the pads perfectly solder free and flat. This is usually a great recommendation for regular boards but the problem with iDevice pads is that they are so thin and so small. It really doesn't take much heat or abrasiveness to rip them from the pcb. Many techs today are using concave tips to wick away (via surface tension) the solder. Then you clean the tip, apply fresh lead-free solder and do the same to apply a thin coat. The pads don't have to be perfectly flat, just consistently flat. This can still lift pads but a lot less frequently than with braid.

Questa risposta è stata utile?

Punteggio 6
Aggiungi un commento

Aggiungi la tua risposta

Benjamin Hong sarà eternamente grato.
Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 619