Salta al contenuto principale

iPhone di quarta generazione. La riparazione è semplice, ma il vetro anteriore e l'LCD andranno sostituiti insieme. GSM / 8, 16, or 32 GB di memoria / Modello A1332 / Nero e Bianco.

2375 Domande Visualizza tutte

How to re-solder the battery terminal back on to the logic board

When I removed the battery terminal, it unclipped using the spudger the first few times then the whole thing came off the logic board. Has anyone got any tips on re-soldering it back on to the logic board. It has four soldered connectors, and the two middle ones have pulled neat squares of the resin material off the logic board, so no solder showing!

Risposto! Visualizza la risposta Anch'io ho questo problema

Questa è una buona domanda?

Punteggio 0
Aggiungi un commento

4 Risposte

Soluzione Prescelta

Battery solder pad came off - How do I fix this?

Questa risposta è stata utile?

Punteggio 2

1 Commento:

sorry my answer was for a 2g.. will do a little more research...

da

Aggiungi un commento

I did this back when I first started soldering on an IBM motherboard Security chip. I never was able to fix it but you can attempt to either scrap the traces it normally connected to and attempt to solder to them, or follow the traces to where it meets up with something and hope the something is large enough to be easy to solder to. Very good eyes and soldering skills are required, also a multimeter can help a lot also.

Good Luck!

Worse case, throw it on ebay, if I saw one on there for cheap enough I would buy it just to try :D.

Questa risposta è stata utile?

Punteggio 0
Aggiungi un commento
Questa risposta era destinata originariamente a un'altra domanda.

any updates?

Questa risposta è stata utile?

Punteggio 0
Aggiungi un commento

I have attempted to resolder the battery connect on, and out of the 4 gold tabs on the back, ive managed to knock one off and loose it... Does this mean the logic board is completely f'd now or can I just tack it to where the gold thing use to be ?

The only problem I had is the solder was not staying melted with a soldering iron. Maybe a hot air gun would be better, or low melt alloy...

Questa risposta è stata utile?

Punteggio 0
Aggiungi un commento

Aggiungi la tua risposta

rachel hutchinson sarà eternamente grato.
Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 3,437