Why doesn't my new battery work?

Question

iPhone 1a Generazione

Il primo modello di iPhone (A1203) con 4, 8 o 16 GB di memoria interna e retro in alluminio. La riparazione potrebbe richiedere alcune saldature e una buona dose di forzature sui componenti.

224 Domande Visualizza tutte

andrewvoelker @andrewvoelker

Rep: 1

1

Postato: 30 set 2010

Opzioni

Why doesn't my new battery work?

I went through the instructions. Getting the case off was difficult. De-soldering and re-soldering the battery went smoothly.

After re-assembly, I put the iPhone 1st gen into a dock to charge. It simply flashes the start screen (apple on black background) -- about 5 seconds on and 2 seconds off.

Perhaps the soldering wasn't perfect? Perhaps there's some other physical problem?

Rispondi a questa domanda Anch'io ho questo problema

Questa è una buona domanda?

Sì No

Punteggio -1

Aggiungi un commento

2 Risposte

russcurtis @russcurtis Rep: 13 1 · Answer 1 · 2010-10-24T13:28:02-07:00

Risposta Più Utile

russcurtis @russcurtis

Rep: 13

1

Postato: 24 ott 2010

Opzioni

I have the same problem. I checked the new battery voltage and it is only .245Mv, therefore, I think it's a bad replacement battery. The old battery shows 3.79V. So, I think I will try putting the old battery back into the phone and check again.

Questa risposta è stata utile?

Sì No

Punteggio 1

2 Commenti:

+ sounds like a good plan to check voltage of batteries

12 nov 2010 da pollytintop

Yes, it was just a bad battery. ifixit quickly sent a replacement and the new battery worked fine.

12 nov 2010 da russcurtis

Aggiungi un commento