Salta al contenuto principale

The Samsung Galaxy Note II is a smartphone noted for its combination of a large display and software optimized for an integral self-storing stylus.

211 Domande Visualizza tutte

After replaceing glass - touch doesn't work very well

Hi,

I've replaced my cracked glass on the Galaxy Note II and everything works well.

However, I can see that the glass is a bit higher than the metal body in the lower part (near the buttons) and the touch isn't working very well in these areas. If I press the glass down hard, it stays there and the touch is working fine then, but after a few minutes it rises up again and the touch doesn't work well (still works, but stutters).

I think it might be because some adhesive was left on the adhesive tape surrounding the body... or maybe while removing the glass, I pulled the LCD up too much...

Do I need to redo the whole procedure?

I even tried keeping the phone under a heavy weight throughout the night but even that didn't work.

Please help!

Amit

Rispondi a questa domanda Anch'io ho questo problema

Questa è una buona domanda?

Punteggio -1
Aggiungi un commento

1 Risposta

Risposta Più Utile

This is most likely due to the previous old adhesive for the old glass not being cleaned on the frame properly and/or newly applied adhesive was too thick causing the touch to be too high and not work properly unless pressed down hard.

I think you need to clean the adhesive very well on the frame then put new adhesive on again. I haven't done glass replacement on the Samsung Galaxy Note II so there may be other things you need to do to get it working reliably.

Questa risposta è stata utile?

Punteggio 1

2 Commenti:

Thanks for replying!

So do I need to buy a new glass? If I remove the glass and I want to put it on again, where do I get new adhesive from?

da

Aggiungi un commento

Aggiungi la tua risposta

Amit sarà eternamente grato.
Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 64