Salta al contenuto principale

L'Apple iPhone 5s è stato presentato il 10 settembre 2013. La riparazione di questo dispositivo è simile a quella dei modelli precedenti e richiede cacciaviti e strumenti di apertura. Disponibile nelle versioni GSM o CDMA con capacità di 16 , 32 o 64 GB nei colori Argento, Oro e Grigio Siderale.

3530 Domande Visualizza tutte
Domanda Chiusa

Update and restore fails

Was given an i5s that had water damage and a cracked screen. Replaced screen. Speaker and battery. Phone powered up fine seemed to work good. I reset phone back to factory and tried to update and start as a new phone not it stops and errors at the firmware section of update. Always codes (1). Cord is good and connections are good. Also noticed battery was getting warm and loosing power quickly. Any help will be appreciated

Rispondi a questa domanda Anch'io ho questo problema

Questa è una buona domanda?

Punteggio 0
Aggiungi un commento

1 Risposta

You are getting error 1? That's not good. This usually implies that the baseband is corrupted. iPhone issues don't really get worse than this. I don't know everything about error 1, but I have saved a few by re-heating the flash memory IC and/or the baseband IC. I usually do it about 330F for 30 seconds with a hot air rework station. This requires removing the rear shield on the motherboard. I think the only other solution is to recall the baseband chip. This is very difficult since you MUST re-use the same baseband chip, you can't just replace it. That chip and the other two baseband related chips on the board are specifically paired with that motherboard. The phone will not work without the original chip. Re-balling requires some pretty serious BGA skills too. I haven't had to courage to attempt it yet. I would seriously recommend finding another motherboard or selling the phone as is

Questa risposta è stata utile?

Punteggio 0
Aggiungi un commento
Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 93