Replaced digitizer, but touch stopped working after a while.
Replaced a broken digitizer on my iPhone 6 plus, following this guide Sostituzione del pannello anteriore dell'iPhone 6 Plus Used the phone with no problems a whole day, then the touch stopped working.
I've reconnected all the connector cables, worked almost a whole new day, then stopped working again. If i turn the device off, and on again the touch works for like 5 minutes before it stops working again.
Any Ideas on how this problem can be resolved?
Questa è una buona domanda?
1 Commento
Did you find any solutions or answers?
I've been repairing phones for 22 years and I have seen this on an iPhone 6 and 6+ now. I only replace with real OEM screens assemblies, and the the screens are tested on other iPhones and they still work fine. But on these two the digitizers, much like the OP, stop working after a minute or two. There is something going on, maybe a digitizer module?
da Peakcelln