Screen Just Went Blank/Black?

Question

iPhone 5

Sesto modello di iPhone Apple, annunciato il 12 settembre 2012. La riparazione si fa in modo simile alle precedenti versioni di iPhone e richiede cacciaviti e strumenti di apertura. Disponibile con tecnologia GSM o CDMA, con 16, 32, o 64 GB, nero o bianco.

2522 Domande Visualizza tutte

ColinY8s @coliny8s

Rep: 1

Postato: 21 mag 2015

Opzioni

Screen Just Went Blank/Black?

Hi,

My iPhone 5 has just developed a fault. The screen has just went completely blank and is black.

The phone makes a noise when it is plugged into the mains to charge, and also when I press the power and home button at the same time to take what would normally be a screen shot. It also vibrates when I put the phone in silent mode.

I initially thought it may be the screen so replaced this as I knew what I was doing as I've replaced quite a few iPhone screens.

I've tried holding the power and home button at the same time but nothing happens, also tried this along with the volume down button. I have restored the phone in iTunes as well but this hasn't resolved the problem either.

Any help with this would be great.

Thanks

Rispondi a questa domanda Anch'io ho questo problema

Questa è una buona domanda?

Sì No

Punteggio -1

1 Commento

Hi,

Thanks for the quick response. Yes, I held both buttons at the same time for up to 30 seconds, but this didn't do anything.

What connectors should I be looking at and are they repairable? I just don't understand how it could be working one minute and then not the next? It wasn't dropped or anywhere near water.

21 mag 2015 da ColinY8s

Aggiungi un commento

2 Risposte

Hi,

Thanks for the quick response. Yes, I held both buttons at the same time for up to 30 seconds, but this didn't do anything.

What connectors should I be looking at and are they repairable? I just don't understand how it could be working one minute and then not the next? It wasn't dropped or anywhere near water. — ColinY8s

Bill Grove @billgrove Rep: 91 2 · Answer 1 · 2015-05-21T08:38:31-07:00

Risposta Più Utile

Bill Grove @billgrove

Rep: 91

2

Postato: 21 mag 2015

Opzioni

Did you actually hold the power and home at the same time for 10 seconds? It's not a quick thing, but needs to be held for 10 seconds (or close to it). If that still doesn't reset it, and you have replaced the LCD, then you're looking at a bad connector or bad chip on the board.

Questa risposta è stata utile?

Sì No

Punteggio 1

Aggiungi un commento