I plugged my 110v hand blender in a 220v power source. It made a flash, and never turned on again, so we can assume its burned, right?
What exactly was damaged?
Is it possible to fix it?
How?
Where do I buy the parts needed to do it?
Questa è una buona domanda?
Rep: 782,2k
1,1k
893
2,3k
pedro, the only way to determine exactly what has overloaded is by taking the blender apart. Most likely it is the caps (potentially a fuse on a circuit board) or even the motor. But, you'll have to take it apart to see what needs to be replaced.
Questa risposta è stata utile?
Hi oldturkey!
Thank you for your message!
So do you think I should take it apart? I am not very experienced in doing stuff like that, but, on the other hand, I don't think I have another choice...
I will open it and post the photos soon!
I definitely would take it apart. Take lots of pictures so you know what goes where. then take a couple of hi-res images of the electronic components and post those to keep us informed.
hi dude, i did the same. could u pl tell what happened to the motor and how to solve the issue
Ultime 24 Ore: 0
Ultimi 7 Giorni: 0
Ultimi 30 Giorni: 1
Tutti i Tempi: 1,138
1 Commento
hi dude, i did the same. could u pl tell what happened to the motor and how to solve the issue
da sunil gupta