Rep: 71
5
9
I recently installed a motherboard in my 667 Onyx.
When the fan ran on the old board it was loud enough to hear. This one I can't tell if the faint sound is just the HD spin or a quieter fan. Does the fan always run or only when it gets hot enough? I sure would like to not tear the Onyx down again.
Questa è una buona domanda?
Rep: 685,3k
3,4k
1,1k
2,6k
You can get this Fan Control software to do the job: http://www.macupdate.com/info.php/id/250...
Questa risposta è stata utile?
+ Ralph
Rep: 71
5
9
This a thanx and a comment to Mr. Mayer.
I almost bought the Fan Control software as you suggested. But the price is confusing, $9.99 or 14.99?
Anyway, I took one last shot at activating the fan. I took an 8X10 jpg and Photoshopped the resolution up to 1600 dpi. In less than a minute the fan kicked in with an audible spin.
I am going to download the Fan Control utility.
Thanx again.
Crocdog
Questa risposta è stata utile?
Rep: 63
3
6
1
I hope you have luck with the G4FanControl. I used it just fine on a 1.67ghz Alum. PowerBook G4, won't work on any DVI, or ANY Titanium model I know of. I've seen other complaints about Fabrizi's "G4FanControl" not working on Titanium models. For that matter, her official site has complaints, just read ALL the testimonials.
Questa risposta è stata utile?
Ultime 24 Ore: 0
Ultimi 7 Giorni: 0
Ultimi 30 Giorni: 0
Tutti i Tempi: 1,834
