iPhone 4 power Logic Board problem?

Question

iPhone 4

iPhone di quarta generazione. La riparazione è semplice, ma il vetro anteriore e l'LCD andranno sostituiti insieme. GSM / 8, 16, or 32 GB di memoria / Modello A1332 / Nero e Bianco.

2375 Domande Visualizza tutte

Gauthier @gauthier32416

Rep: 45

2

3

Postato: 23 dic 2012

Opzioni

iPhone 4 power Logic Board problem?

I got here an iPhone 4 which only boot with a pre-charged battery.

If the battery runs down, I can charge it, but the charge icon don’t go away and it’s impossible to boot.

I replaced the dockconnector an battery twice, but without result. There are also no marks of waterdamage, the device looks fine inside, except 1 thing is damaged (http://img834.imageshack.us/img834/1862/...)

Could this be the cause of the problem? Someone who has got the same problem?

Rispondi a questa domanda Anch'io ho questo problema

Questa è una buona domanda?

Sì No

Punteggio -1

3 Commenti

Strange problem. I don't know if that part could cause problems. If your sure this part is broken you could bridge it. Is your battery connector firmly in place..?

23 dic 2012 da Jordy

Yes, the battery connector looks fine. Ok, I'll try to bridge the contact points of the broken part.

23 dic 2012 da Gauthier

Bridging also doesn't work..

24 dic 2012 da Gauthier

Aggiungi un commento

2 Risposte

Strange problem. I don't know if that part could cause problems. If your sure this part is broken you could bridge it. Is your battery connector firmly in place..? — Jordy
Yes, the battery connector looks fine. Ok, I'll try to bridge the contact points of the broken part. — Gauthier

oldturkey03 @oldturkey03 Rep: 781,6k 1,1k 893 2,3k · Answer 1 · 2012-12-24T09:32:09-07:00

Risposta Più Utile

oldturkey03 @oldturkey03

Rep: 781,6k

1,1k

893

2,3k

Postato: 24 dic 2012

Opzioni

Gauthier Top, the part that you showed on the image is a SMD capacitor 27PF 5% NP0-C0G. I do have to say that bridging components is not always a wise choice, if bridging would always work, the components would not be necessary, and the manufacturers could/ would eliminate those. So, you can try and replace it, if you know how to work with very small components and have the right tools. Otherwise you cold get it repaired by a local electronics shop. Hope this helps, good luck.

Questa risposta è stata utile?

Sì No

Punteggio 1

Aggiungi un commento