⟐ Answered luglio 28, 2022 at 17:23 GMT-7

⟐ Answered luglio 24, 2022 at 20:29 GMT-7

I tried a hard reset, factory reset with itunes but the screen keeps black. Any suggestion? thanks

⟐ Commented luglio 14, 2021 at 15:06 GMT-7

I have iPhone X 64 GB and i have a isue that is pretty strange.

Mobile, have broken glass back and screen too, but i changed screen and the problem is still the same. Everything works, just one thing, that was before and after screenreplacement.

Rear camera doesn´t work on Camera app, front camera works fine, face id also, flash too, bet rear camera it just how to say stucks, freazes, it tries to focus and then show a image blury and freazes, if you try to focus somethin else you wait like 30 seconds and it focus that thing but still image is blurry and it doesn´t move, until you try to focus something else again and wait couple seconds and see again blurry dark picture.

If i go to Instagram app and try to open camera doesn´t work ether, but if i go to snapchat or messenger/facbook, rear camera working smoth as !&&*.

I tried to

• deactivet, activet location service.
• Reinstaled (factor settings)
• Hardreset
• DFU mode
• Updates

Help me, should i change camera lens or something to do with logicboard ( and logicboard i know nothing). Changing parts i can it´s easy.

⟐ Commented aprile 28, 2021 at 15:29 GMT-7

i hope you are well.

please find the attached image as I am struggling to get my iPhone X off emergency mode.

please help''

''

⟐ Answered novembre 27, 2020 at 23:51 GMT-7

⟐ Commented novembre 13, 2020 at 8:12 GMT-7

⟐ Commented aprile 30, 2020 at 6:39 GMT-7

⟐ Commented aprile 09, 2019 at 12:25 GMT-7

⟐ Answered dicembre 07, 2018 at 2:49 GMT-7

i have done every reset possible, different sims, put original battery back in. Replaced the antenna cable bracket(With flex) on bottom, I also replaced the loud speaker flex (also known as interconnect flex cable ) being the cell antenna bracket connects to it. Still same issue. Anyone have any idea? Thanks

⟐ Commented gennaio 22, 2021 at 4:23 GMT-7

I’ve tried putting the phone into DFU mode by pressing the volume up bottom, then the volume down button then the power button it then goes to the restore screen where it asks to plug it into itunes. Itunes doesn’t detect the phone at all, was expecting it to prompt me to restore and update like it normal does.

Have been thinking about replacing the battery to see if that’s the issue as it doesn’t seem to be taking charge at all

Any help would be massively appreciated

Hi everyone, the situation has now advanced in a good way! I disconnected the battery, disconnected the screen and then connected the battery back up. Pressed up, then down then held the sleep key and to be shock it detected the phone!

From here I restored the phone and updated to IOS 13. I’ve now got to the welcome stage of the phone on iTunes however when I connect the screen back up it goes back into a boot loop!

The screen appears to be the issue here I recon. Should I just get a new screen? I’ve checked the connections on the motherboard and they seem okay no visible damage or dust in there. Not too sure what to do

⟐ Commented marzo 17, 2024 at 12:36 GMT-7

⟐ Commented febbraio 17, 2020 at 21:13 GMT-7

So I dropped my iPhone X in the sink. No big deal, I’ve done it a few times before and nothing has come of it. It’s IP67 rating, so it should’ve been fine. I understand now that the gasket wears out over time, but hindsight is 20/20.

A little while after I dried my iPhone off (it was still working perfectly), I put it in my pocket and forgot about it for a few hours. I take it out of my pocket to find that it was bootlooping.

I’ve looked all over online to see what the cause of this was, and I decided to open up my iPhone. The insides looked fine. There was a little condensation on the rear camera glass, but nothing major. I decide to try to boot the phone without the earpiece assembly plugged in, and it worked!

Great, I thought. I’ll just replace the assembly and all should be well. Then I look up how much it is, and see a note at the bottom of the page.

“The Earpiece Speaker and Sensor Assembly is paired to the logic board in an iPhone X. This assembly contains the flood illuminator, which is part of the Face ID security feature. Replacing this assembly will not restore Face ID functions. “

Now I feel like garbage. This is my personal phone, I’ve only had it for about a year, and my dreams of just replacing a part to get it like new again is gone.

Now for the questions. I understand that the earpiece assembly is paired to the logic board. Is there any way whatsoever to spoof the pairing of the two?

I didn’t find any visible damage on the assembly itself, not even the ribbon cable. But the connector on the logic board looks like it has a few dark spots on the top right few pins. Is there any way of cleaning the logic board up and possibly getting it to work?

Should I just cut my losses, lose face id, and just replace the assembly?

Should I just take the assembly out and lose the ability to use the speaker and have the iPhone adjust brightness levels automatically? Also along with face id?

In other words, I’m just looking for suggestions on what to do. Any help would be greatly appreciated.

⟐ Commented marzo 30, 2023 at 13:54 GMT-7

⟐ Answer edited ottobre 18, 2024 at 1:03 GMT-7

My iPhone X 256 GB face ID is not working after a water damage, phone is working perfectly except FACE ID, apple denied repair. Is there any way we can repair Face ID. I can't replace my mobile by paying $500

⟐ Commented agosto 16, 2023 at 10:50 GMT-7

⟐ Answered gennaio 19, 2023 at 19:06 GMT-7

On internet I didn’t found nothing like that, can anyone please help me?

thank you in advance!

⟐ Answered ottobre 30, 2021 at 11:32 GMT-7

⟐ Commented settembre 05, 2020 at 2:44 GMT-7

⟐ Commented aprile 30, 2020 at 22:58 GMT-7

⟐ Commented marzo 17, 2019 at 6:47 GMT-7