Salta al contenuto principale
Aiuto

Post originale di: oldturkey03 ,

Testo:

Kim, it is a common fault with this model. You will have to do it in stages. Remove the drive as shown on [guide|5780|on here.] then first you remove the terminal PCB by unscrewing the screws, then desolder the solder connection and remove the connectors.

[image|174956]

Next you remove the clamp plate unit by spreading the the stopper with your hand, slide the tabs and remove the clamp plate unit.

[image|174957]

[image|174958]

Next lift the tray.

[image|174959]

Lift the traverse block while spreading the hook of the mechanical chassis unit. Disengage the tabs from the holes of the mechanical chassis unit.

[image|174960]

Disengage the tabs from the traverse gear. remove the traverse gear B and C.

[image|174961]

[image|174962]

Remove the optical pickup unit by unscrewing the screws. remove the spring holders and the springs. Pull out the drive shaft and guide shaft.

[image|174963]

Disassemble the Middle chassis by removing the holder pins and remove the tab. It lifts while pulling it in the direction of the arrow in the image.

[image|174964]

Next remove the traverse gear A in the image.

[image|174966]

Remove the floating rubbers. This will now give you access to the spindle motor unit.

[image|174967]

The spindle motor part number as RXQ0745B. hope this helps, good luck.

Stato:

open