Salta al contenuto principale
Aiuto

Versione corrente di: ben ,

Titolo:

MacBook shuts down after AC is unplugged

Testo:

Hey!

I have a Macbook air and I am trying to figure out what is wrong with it. The macbook doesn't work without the AC plugged in. The battery does charge after I disconnect and then reconnect the battery and the I/O flex cable. But when I reboot it after that it stops charging again and only shows a green indicator. Hardware test, SMC reset, PRAM reset and complete factory reset did not do anything.

Battery info is:

* Battery Information:
* Model Information:
* Serial Number:    D8612460820DKRNA7
* Manufacturer:    SMP
* Device Name:    bq20z451
* Pack Lot Code:    0
* PCB Lot Code:    0
* Firmware Version:    406
* Hardware Revision:    1
* Cell Revision:    162
* Charge Information:
* Charge Remaining (mAh):    3356
* Fully Charged:    No
* Charging:    No
* Full Charge Capacity (mAh):    5888
* Health Information:
* Cycle Count:    727
* Condition:    Normal
* Battery Installed:    Yes
* Amperage (mA):    18
* Voltage (mV):    7739

Everything is original in the macbook and I have already tried it with other chargers.

My main question now is: can I find out if it is the battery, the I/O board or the I/O flex cable?

Dispositivo:

MacBook Air 13" Mid 2011

Stato:

open

Risposta Accettata:

+425478

Modifica di: ben ,

Titolo:

MacBook shuts down after AC is unplugged

Testo:

Hey!
-I have a Macbook air and I am trying to figure out what is wrong with it. The macbook doesn't work without the AC plugged in. The battery does charge after I disconnect and then reconnect the battery and the I/O flex cable. But when I reboot it after that it stops charging again and only shows a green indicator.
+I have a Macbook air and I am trying to figure out what is wrong with it. The macbook doesn't work without the AC plugged in. The battery does charge after I disconnect and then reconnect the battery and the I/O flex cable. But when I reboot it after that it stops charging again and only shows a green indicator. Hardware test, SMC reset, PRAM reset and complete factory reset did not do anything.
-battery info is:
+Battery info is:
* Battery Information:
* Model Information:
* Serial Number: D8612460820DKRNA7
* Manufacturer: SMP
* Device Name: bq20z451
* Pack Lot Code: 0
* PCB Lot Code: 0
* Firmware Version: 406
* Hardware Revision: 1
* Cell Revision: 162
* Charge Information:
* Charge Remaining (mAh): 3356
* Fully Charged: No
* Charging: No
* Full Charge Capacity (mAh): 5888
* Health Information:
* Cycle Count: 727
* Condition: Normal
* Battery Installed: Yes
* Amperage (mA): 18
* Voltage (mV): 7739
Everything is original in the macbook and I have already tried it with other chargers.
My main question now is: can I find out if it is the battery, the I/O board or the I/O flex cable?

Dispositivo:

MacBook Air 13" Mid 2011

Stato:

open

Modifica di: ben ,

Titolo:

MacBook shuts down after AC is unplugged

Testo:

Hey!
-I have a Macbook air and I am trying to figure out what is wrong with it. The macbook doesn't work without the AC plugged in. The battery does charge after I disconnect and then reconnect the battery and the I/O flex cable. But when I reboot it after that it stops charging again.
+I have a Macbook air and I am trying to figure out what is wrong with it. The macbook doesn't work without the AC plugged in. The battery does charge after I disconnect and then reconnect the battery and the I/O flex cable. But when I reboot it after that it stops charging again and only shows a green indicator.
battery info is:
* Battery Information:
* Model Information:
* Serial Number: D8612460820DKRNA7
* Manufacturer: SMP
* Device Name: bq20z451
* Pack Lot Code: 0
* PCB Lot Code: 0
* Firmware Version: 406
* Hardware Revision: 1
* Cell Revision: 162
* Charge Information:
* Charge Remaining (mAh): 3356
* Fully Charged: No
* Charging: No
* Full Charge Capacity (mAh): 5888
* Health Information:
* Cycle Count: 727
* Condition: Normal
* Battery Installed: Yes
* Amperage (mA): 18
* Voltage (mV): 7739
+
Everything is original in the macbook and I have already tried it with other chargers.
My main question now is: can I find out if it is the battery, the I/O board or the I/O flex cable?

Dispositivo:

MacBook Air 13" Mid 2011

Stato:

open

Modifica di: ben ,

Titolo:

MacBook shuts down after AC is unplugged

Testo:

Hey!
I have a Macbook air and I am trying to figure out what is wrong with it. The macbook doesn't work without the AC plugged in. The battery does charge after I disconnect and then reconnect the battery and the I/O flex cable. But when I reboot it after that it stops charging again.
battery info is:
-Battery Information:
-Model Information:
-Serial Number: D8612460820DKRNA7
-Manufacturer: SMP
-Device Name: bq20z451
-Pack Lot Code: 0
-PCB Lot Code: 0
-Firmware Version: 406
-Hardware Revision: 1
-Cell Revision: 162
-Charge Information:
-Charge Remaining (mAh): 3356
-Fully Charged: No
-Charging: No
-Full Charge Capacity (mAh): 5888
-Health Information:
-Cycle Count: 727
-Condition: Normal
-Battery Installed: Yes
-Amperage (mA): 18
-Voltage (mV): 7739
-
+* Battery Information:
+* Model Information:
+* Serial Number: D8612460820DKRNA7
+* Manufacturer: SMP
+* Device Name: bq20z451
+* Pack Lot Code: 0
+* PCB Lot Code: 0
+* Firmware Version: 406
+* Hardware Revision: 1
+* Cell Revision: 162
+* Charge Information:
+* Charge Remaining (mAh): 3356
+* Fully Charged: No
+* Charging: No
+* Full Charge Capacity (mAh): 5888
+* Health Information:
+* Cycle Count: 727
+* Condition: Normal
+* Battery Installed: Yes
+* Amperage (mA): 18
+* Voltage (mV): 7739
Everything is original in the macbook and I have already tried it with other chargers.
My main question now is: can I find out if it is the battery, the I/O board or the I/O flex cable?

Dispositivo:

MacBook Air 13" Mid 2011

Stato:

open

Modifica di: ben ,

Titolo:

MacBook shuts down after AC is unplugged

Testo:

Hey!
I have a Macbook air and I am trying to figure out what is wrong with it. The macbook doesn't work without the AC plugged in. The battery does charge after I disconnect and then reconnect the battery and the I/O flex cable. But when I reboot it after that it stops charging again.
battery info is:
Battery Information:
-
Model Information:
-
Serial Number: D8612460820DKRNA7
-
Manufacturer: SMP
-
Device Name: bq20z451
-
Pack Lot Code: 0
-
PCB Lot Code: 0
-
Firmware Version: 406
-
Hardware Revision: 1
-
Cell Revision: 162
-
Charge Information:
-
Charge Remaining (mAh): 3356
-
Fully Charged: No
-
Charging: No
-
Full Charge Capacity (mAh): 5888
-
Health Information:
-
Cycle Count: 727
-
Condition: Normal
-
Battery Installed: Yes
-
Amperage (mA): 18
-
Voltage (mV): 7739
Everything is original in the macbook and I have already tried it with other chargers.
My main question now is: can I find out if it is the battery, the I/O board or the I/O flex cable?

Dispositivo:

MacBook Air 13" Mid 2011

Stato:

open

Post originale di: ben ,

Titolo:

MacBook shuts down after AC is unplugged

Testo:

Hey!

I have a Macbook air and I am trying to figure out what is wrong with it. The macbook doesn't work without the AC plugged in. The battery does charge after I disconnect and then reconnect the battery and the I/O flex cable. But when I reboot it after that it stops charging again.

battery info is:

Battery Information:

Model Information:

Serial Number:    D8612460820DKRNA7

Manufacturer:    SMP

Device Name:    bq20z451

Pack Lot Code:    0

PCB Lot Code:    0

Firmware Version:    406

Hardware Revision:    1

Cell Revision:    162

Charge Information:

Charge Remaining (mAh):    3356

Fully Charged:    No

Charging:    No

Full Charge Capacity (mAh):    5888

Health Information:

Cycle Count:    727

Condition:    Normal

Battery Installed:    Yes

Amperage (mA):    18

Voltage (mV):    7739

Everything is original in the macbook and I have already tried it with other chargers.

My main question now is: can I find out if it is the battery, the I/O board or the I/O flex cable?

Dispositivo:

MacBook Air 13" Mid 2011

Stato:

open