Salta al contenuto principale
Aiuto

Post originale di: originalmachead ,

Testo:

== The ==

DC in boards '''should be the same part numbers...''' you can look for "burned" spots or corrosion spots on the logic board ''(don't forget to look underneath)''.

The corrosion can be cleaned, the burned spots may indicate blown components... they are very hard to replace ''(soldering logic boards requires special skill and materials)''.

If the DC boards did match you might clean it (so further corrosion does not damage the machine) and use it as is, buy a replacement logic board or part out the machine.

'''Remember to return and mark accepted the answer that best solves your problem.'''

Good luck,

N

Stato:

open