Salta al contenuto principale
Aiuto

Versione corrente di: dovedescent7 ,

Testo:

I could have. The problem wasn't the adhesive I used. I attempted using 2mm redtape from etech,over each rubber button, but problem was, now matter how much heat I put on, the buttons really wouldn't stay seated for some reason. I even wiped area with alcohol.
I ordered a whole lower charger port assembly, but my real question is, these buttons don't Light up EVER...
do you know exactly what
+-mechanism-? drives power to the actual lights for these buttons??? Is it a flex cable? I don't remember now that I can't see it. help!
--mechanism-? drives power to the actual lights for these buttons??? Is it a flex cable? I don't remember now that I can't see it. help!
+And YES I have already tried the power Saving mode solution..
+THIS IS A mechanical failure.
+But where?

Stato:

open

Post originale di: dovedescent7 ,

Testo:

I could have. The problem wasn't the adhesive I used. I attempted using 2mm redtape from etech,over each rubber button, but problem was, now matter how much heat I put on, the buttons really wouldn't stay seated for some reason. I even wiped area with alcohol.

I ordered a whole lower charger port assembly, but my real question is, these buttons don't Light up EVER...

do you know exactly what

-mechanism-?  drives power to the actual lights for these buttons??? Is it a flex cable?  I don't remember now that I can't see it. help!

Stato:

open