Salta al contenuto principale
Aiuto

Versione corrente di: scottbernardis ,

Testo:

[image|514260]
+1. end cover, and cover plate removed.
[image|514259]
+2. close up of broken mount point (under/behind blue wire)
[image|514258]
+3. inner broken-off arm removed, was completely free
Well, I removed the 3 large screws in the end face of the icemaker, under the cover.
As soon as I got it open, I could see the inner control arm, that operates the external arm, had it's base broken off of the housing. Since this part undergoes pressure from both motor and connected spring, I don't think I will have any luck repairing it (gluing plastic back into plastic), and I'm going to call this part of the repair a total bust, unless I hear recommendations to the contrary.
'''I don't know enough to say if fixing the arm would remedy the missing cycle initiation or not.'''

Stato:

open

Post originale di: scottbernardis ,

Testo:

[image|514260]

[image|514259]

[image|514258]

Well, I removed the 3 large screws in the end face of the icemaker, under the cover.

As soon as I got it open, I could see the inner control arm, that operates the external arm, had it's base broken off of the housing.  Since this part undergoes pressure from both motor and connected spring, I don't think I will have any luck repairing it (gluing plastic back into plastic), and I'm going to call this part of the repair a total bust, unless I hear recommendations to the contrary.

'''I don't know enough to say if fixing the arm would remedy the missing cycle initiation or not.'''

Stato:

open